American Sanders OBS-18 운영자 안전 지침 - 페이지 7
{카테고리_이름} American Sanders OBS-18에 대한 운영자 안전 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Sanders OBS-18 7 페이지. Clarke oscillating sander
American Sanders OBS-18에 대해서도 마찬가지입니다: 운영자 지침 (2 페이지)
페이지 인쇄
Sanding Cuts and Sandpaper
Initial Cut
The purpose of the initial cut is to remove old finish and gross imperfections on the floor surface. Use a
course (20-36 grit) grain abrasive.
Final Cuts
The purpose of a finishing cut is to remove the scratches produced during the initial cut. Use a fine (60-80
grit) grain abrasive.
If the surface remains rough after a finishing cut, it may be necessary to use an even finer grain of abrasive
(80-100grit). Care should be taken in selecting the grit size of the abrasive. A very fine grain will close the
pores on a wood floor making admission of a stain difficult.
If glazing or burning should occur the abrasive has dulled and must be replaced.
Grain
For removing gross imperfections and restoring
20 grit
evenness to old flooring. To remove buildup of
paints and varnishes
For the first sanding of new flooring (maple, oak).
36 grit
For removing minor imperfections and finishes
from old flooring.
60 grit
For clean-up from initial cut 36 grit.
60 grit
screen mesh
80 grit
For final sanding of certain hardwoods. For
80 grit
clean-up of cuts (60 grit).
screen mesh
100 grit
For final sanding of certain hardwoods and
100 grit
conifers where a smooth surface is desired.
screen mesh
120 grit
For final sanding of certain hardwoods and
screen mesh
conifers where a smooth surface is desired.
For leveling after initial finish coat.
150 grit
For scratching surface between coats of finish
screen mesh
180 grit
For surface roughing between coats of finish.
screen mesh
Clarke
®
American Sanders
Use
Operator's Manual (EN) - OBS-18/18DC
ENGLISH
Standard
Professional
Grade
Grade
Part #/Qty.
Part #/Qty.
945950/10
945951/20
945954/20
945960/20
945955/20
945961/20
945956/20
945962/20
945963/20
945964/20
EN
- 9 -