American Sanders AVAC18 운영자 매뉴얼 - 페이지 13
{카테고리_이름} American Sanders AVAC18에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Sanders AVAC18 20 페이지.
페이지 인쇄2
To start working, do as follows:
1. Carry out all the checks in the section
2. Insert the plug (1) of the power supply cable (2) in the electrical
supply socket (3) (Fig.1).
3. Switch on the machine by positioning one of the two switches (4)
to the work position "I" (Fig. 2).
1
At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
1. Do what is required to make sure the machine is in a safe
condition (see
MACHINE
2. Take the appliance to the designated place for emptying the
collection tank.
ATTENTION: the place designated for this operation must
comply with current environmental protection regulations.
3. Empty the collection tank (see the section
CLEANING THE COLLECTION
4. Remove the accessory from the extension, clean it with a damp
cloth.
ATTENTION: When it is completely dry insert it into the
accessories support on the rear of the collection tank (optional
accessory).
2
1
1
5
"PREPARING TO
3
2
1
2
AT THE END OF THE WORK
SAFETY'").
"CHECKING AND
BAG").
1
6
WORK
ATTENTION: to double the vacuum capacity progressively
activate the other switch.
WORK".
4. Proceed with the vacuuming.
ATTENTION: "If, when working, the intensity of the vacuum
should drop, read the chapter
ON
4
5. Remove the female part of the extension from the male part, clean it
under running water.
ATTENTION: When it is completely dry insert it into the
accessories support on the rear of the collection tank (optional
accessory).
6. Remove the vacuum hose (1) (Fig.1) from the vacuum nozzle (2) in
the cover of the collection tank, clean it under running water.
ATTENTION: When it is completely dry insert it into the
accessories support on the rear of the collection tank (optional
accessory).
ATTENTION: park the appliance in an enclosed place, on a flat
surface; near the appliance there must be no objects that could
either damage it, or be damaged through contact with it.
13
7
6
7
CONTROL AND
OPERATION".