123Filter iSpring 설치 지침 - 페이지 10
{카테고리_이름} 123Filter iSpring에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. 123Filter iSpring 15 페이지. Reverse osmosis water filter systems
123Filter iSpring에 대해서도 마찬가지입니다: 소유자 매뉴얼 (9 페이지)
페이지 인쇄
Step 6: Install Reverse Osmosis Membrane
6.1 Open the membrane housing screw cap. First, you will need to disconnect the white 1 / 4" tubing from the
Inlet quick-fitting on the membrane housing cap (refer to How to Use Quick-Fitting section), and then
unscrew (counter-clockwise) the cap. A thick rubber band can be slipped on the housing body for a stronger
hand hold.
6.2 Remove the membrane from its sealed bag. Follow the flow direction sign on the membrane, and firmly
insert the membrane into the housing with the smaller end that has two black O-rings heads first until the
bigger end is even with the housing opening. See Figure 8-9.
6.3 Before twisting the housing cap back on, check that the O-ring is evenly snagged on the membrane
housing (cap does NOT have O-ring). Hang tight and tighten up for about 1 /4 – 1 /2 turns using a small
plastic housing wrench, but do not over tighten. DO NOT reconnect the tubing to inlet on cap at this point
(will do it in system start up).
Step 7: Tubing Hook up (model specific sub-steps are marked with * )
7.1 See Figure 5 and Figure 10 RCC7P & RCC7 TOP VIEW, note connection points A-B, C-D, E-F, and G-H.
www.123filter.com
Figure 8
| (678) 261-7611
Figure 9
Page 9