American Sportworks 5210 사용 설명서/부품 설명서 - 페이지 10

{카테고리_이름} American Sportworks 5210에 대한 사용 설명서/부품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. American Sportworks 5210 20 페이지. 208cc fun kart
American Sportworks 5210에 대해서도 마찬가지입니다: 조립 지침 (3 페이지)

페이지 인쇄

1. Replacement Parts

maintenance

H. Rear Wheel Replacement

Remove cotter pin and castle nut. Wheel should be easily removed. After replacing the wheels,

tighten castle nut and replace cotter pin with a new one. Replace rubber cover

I. Front Wheel Alignment

The front wheels should be set with a "toe-in" from 1/4" to 1/2". At the centerline of the tires,

measure the Distance A and the Distance B. For proper toe adjustment, Dimension A should

be 1/4" – 1/2" greater than Dimension B. While adjusting, ensure rubber boots are in good

condition.

To make adjustments:

1) Loosen the lock nuts on both sides of Front Tie Rods.

2) Ensure the steering wheel is centered, and adjust Dimension B by equally rotating the

tie rod adjusting sleeve in or out with a 12mm wrench.

3) After adjusting to the desired length, tighten the lock nuts against the Tie Rods.

4) Recheck the dimensions for proper alignment.

Right Rotate

Left Rotate

J. Storage Instruction

If you plan to store (and not operate) your kart for a period in excess of 30 days, or at the end of each driving season, the unit should be set up for

storage as follows:

a. Drain fuel tank and carburetor by allowing the engine to run completely out of fuel.

b. Lubricate the engine cylinder by using an engine fogging oil, following the instructions provided with the product.

c. Do NOT save or store gasoline over the winter. Using old gasoline, which will deteriorate from storage, will make the engine difficult to start and

affect the performance of the engine.

d. Remove the battery from the unit and apply a periodic trickle charge to maintain the battery at a proper voltage level for the next riding season.

e. To protect the paint, plastics and upholstery, it is a good idea to keep the unit covered when not in use.

Prevailing torque type locknuts must be replaced with new after the old locknuts are removed.

15362R1

(see fig. H1)

(see fig. I1)

Toe Adjustment Diagram

5210 OWNERS MANUAL / ILLUSTRATED PARTS LIST

SECTION 3

fig. H1

Right Rotate

Left Rotate

CAUTION

Lock Nuts

Tie Rod Adjusting Sleeve

fig. I1