American Standard 3351 설치 지침 - 페이지 2

{카테고리_이름} American Standard 3351에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard 3351 2 페이지. Afwall flush valve wall-mounted toilets
American Standard 3351에 대해서도 마찬가지입니다: 설치 지침 (2 페이지)

페이지 인쇄

Place back-up nuts on both bottom bolts, and

the top left-hand bolt only.

Adjust the two lower back-up nuts so that front

face of nuts is flush with finished wall.

Adjust waste horn to project 5/16" (7mm) from

finished wall.

CLOSET

CARRIER

SYSTEM

NOTE: Bearing nuts and washers must be set to take full loading from the fixture allowing

1/16" (2mm) clearance between fixture and wall.

Follow support manufacturer's recommended setting of closet outlet connection.

Place felt or neoprene gasket (wax ring not recommended) on closet outlet.

When the fixture is installed, closet outlet gasket must be compressed sufficiently to

assure a gas and watertight seal.

The following steps require a helper:

Install bowl on support using cap nuts and fiber washers with the back-up nuts and washers.

DO NOT APPLY TOP RIGHT FIBER WASHER AND CAP NUT UNTIL OTHER CAP NUTS

HAVE BEEN FIRMLY TIGHTENED USING A WRENCH.

Install top right cap nut with fiber washer and run up hand tight. Wrench tighten approximately

1/4 turn.

Apply sealant to gap between bowl and finished wall. Remove excess sealant.

In the United States:

American Standard Brands

P.O. Box 6820

Piscataway, New Jersey 08855

Attention: Director of Consumer Affairs

For residents of the United States, warranty

information may also be obtained by calling

the following toll free number: (800) 442-1902

www.americanstandard.com

730 1 1 15 - 1 0 0 R e v . C

FINISHED WALL

(3) NUTS

WASTE

HORN

5/16" (7mm)

In Canada:

AS Canada ULC

5900 Avebury Ave.

Mississauga, Ontario

Canada L5R 3M3

Toll Free: (800) 387-0369

www.americanstandard.ca

- 2 -

Using a level, adjust the top left back-up nut so that

it is in the same vertical plane as the lower left back-up

nut. (If wall surface is irregular, the three back-up

nuts must be positioned to allow a minimum 1/16"

gap between fixture and wall surface.)

FINISHED WALL

1/16" (2mm)

(IRREGULAR

WALL SURFACE)

LEVEL

In Mexico:

Customer Service Manager

AS Maquila, S.A. de C.V.

Via Morelos #330

Col. Santa Clara

Ecatepec 55540 Edo. Mexico