American Standard 3404 설치 및 관리 매뉴얼 - 페이지 4

{카테고리_이름} American Standard 3404에 대한 설치 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard 3404 5 페이지. 2-piece toilets

페이지 인쇄

With correct washers in

place (see Step 9a),

tighten COUPLING NUT

1/4 turn beyond hand tight.

DO NOT OVERTIGHTEN.

TROUBLE SHOOTING FLUSH VALVE

SEAL REPLACEMENT:

1. Turn off water supply and flush toilet to empty tank.

2. Disconnect chain from trip lever by removing hair pin cotter

and clevis pin.

3. Parially lift and support piston bottom with one hand.

4. Remove thumbscrew by turning counter-clockwise.

5. Remove piston top and gasket.

6. Replace gasket with new gasket.

7. Reverse procedure, turn thumbscrew until 2 clicks are felt.

HAIR PIN

COTTER

NOTE: DO NOT ADD ANY FOREIGN MATERIALS TO THE SEALING SURFACE.

Turn on water supply.

Submerge the FLOAT

CUP under the water for

30 seconds. Adjust the

water to desired level by

turning WATER LEVEL

ADJUSTMENT ROD

and moving FLOAT

CUP up or down.

THUMBSCREW

PISTON TOP

GASKET

PISTON BOTTOM

TOP

CRITICAL LEVEL

MARK ("C.L.")

MUST BE

1" ABOVE

OVERFLOW PIPE

FILL

VALVE

BODY

SHANK

WASHER

LOCK NUT

CONE WASHER

COUPLING NUT

(HAND TIGHT ONLY)

ADJUSTMENTS

a. Adjust water level. Water level should be adjusted to level indicated in

tank by adjusting float cup. See Step 11 for water level adjustment method.

IMPORTANT:

b. If bowl fails to siphon, an adjustment may be required with the lift chain.

Simply remove the bead chain from the retainment clip (see Fig. 10A)

and take up slack on the chain, and reinsert on lift rod. Make sure the chain

is not too taught.

CARE AND CLEANING

When cleaning your toilet, wash it with mild, soapy water, rinse

thoroughly with clear water and dry with a soft cloth.

WARNING:

can seriously damage fittings in the tank. This damage can

cause leakage and property damage.

American Standard shall not be responsible or liable for

any damage caused by the use of in-tank cleaners.

13a

REFILL TUBE REPLACEMENT :

- 4 -

ARM NIPPLE

REFILL

TUBE

TANK

LEVER

FLOAT

CUP

WATER LEVEL

ADJUSTMENT

ROD

ADJUSTABLE

HEIGHT

THREADED

SHANK

PARTS FOR WATER

CONNECTION

(SEE STEP 9)

Diagram 1

Do not use in-tank cleaners. These products

Locate bottom portion of

hose clip to vent tube at

location as shown.

73052 9 -10 0 Rev. U

Fig. 10A