Akura MSD306 빠른 시작 매뉴얼

{카테고리_이름} Akura MSD306에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Akura MSD306 3 페이지. Msd306
Akura MSD306에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (3 페이지)

페이지 인쇄
Akura MSD306 빠른 시작 매뉴얼
GETTING STARTED
1.
Please read the safety section (page 2) in the main instructions before proceeding further. This section
contains vital information to ensure safe positioning and use of the TV
2.
Unpack the TV and place on a flat level surface suitable to support the weight of the TV (5.68 kg approx.).
3.
Connect the aerial into the TV Tuner connector at the left side of the TV (Fig 1).
Fig 1
4.
Connect the mains power lead to the Power Input socket at the rear of the TV,
(Fig 2) Plug in and switch on at the mains. The LED indicator on the TV will
illuminate and show red (Fig 3).
5.
Open the battery compartment cover (Fig 4) on the reverse of the remote
control. Insert 2 x AAA 1.5V alkaline batteries in accordance with the diagram in
the battery compartment. Take care to observe the correct polarity (+/-).
6.
Press the POWER button (Fig 5) to turn the TV set on. The LED indicator will
turn green and after a few seconds, the screen will activate and the first time
installation menu (Fig. 6) will appear.
7.
Use the cursor ▼/▲ buttons on the remote control to move up and down the
display to highlight desired options.
8.
The default language is "English" if you want another language select that
language using the ►/◄ buttons. Use the ▼/▲ buttons to select "COUNTRY"
and use the ►/◄ buttons to select another country if required. (If using in the
Rep of Ireland, select Belgium). Use the ▼/▲ buttons to select "Tune Type" and
use the ►/◄ buttons to select either ATV, DTV or ATV-DTV. (ATV-DTV is
default. If using in the Rep of Ireland, select ATV).
9.
Press Ok. Fig 7 will be displayed. The TV will now search the entire UHF range
for both Digital and Analog TV stations. When search is complete the TV will
display the first channel (BBC1) in DTV mode. To view a list of received stations
press "LIST", "Fig 8". The Analog stations may not be in the correct order, see
page13 in the Main Instruction book for more information.
10.
To select a channel either enter the number of the channel using the number
buttons on the remote control or scroll through the channels using the channel
CH+/- buttons.
11.
To view analogue TV channels press the SOURCE/INPUT button to display the
source menu "Fig 9". Using the cursor ▲ / ▼ buttons highlight TV on the menu
and press OK to select. To view digital TV channels select DTV on this same
menu.
APLDVD2YR2268VH

Quick Start Guide

Fig.2
Fig.8
MSD306
Fig.3
Fig.9
Fig.4
Fig.5
Fig.6
Fig.7