Barksdale BLS3000 사용 설명서 - 페이지 6

{카테고리_이름} Barksdale BLS3000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Barksdale BLS3000 6 페이지. Dual level switch

페이지 인쇄

AEP**

dPA**

ErS.A**

COF

ddis

Fdis

udiS

Firm

Factory

setting

Analog end

max ... x %

****

Damping,

0... 50 s

0 s

analog output

Error,

Off - > 22 -

Off

analog signal

< 3.6

Maximum peak

value

Delete

Minimum peak

norm.

value

Delete

Offset (10 % of

measuring range)

Damping display

0... 50 s

0 s

Function display

norm. –

norm.

rot.

Unit indication

ON - OFF

Off

Firmware

version

only models with 2nd switching contact

only models with analog output

***

no automatic conversion

If the unit and/or the display of the measured values are changed all parameters for switching points

or analog output must be checked and adjusted as required.

setting according to measuring range

****

Software lock

Key lock

5 sec.

Display

Maintenance/Cleaning

Maintenance

The level switch requires no maintenance.

WARNING

Check the switch for functioning at regular intervals. If the switch does not work properly, stop operation

immediately.

Cleaning

CAUTION

The switch may be damaged by the use of unsuitable cleaning agents.

The following cleaning agents may be used to clean polycarbonates:

- Mild soap or detergents

- Isopropyl alcohol

After cleaning, immediately rinse with water. Do not leave cleaners on surfaces of products.

Do not clean products at elevated temperatures or under direct sunlight.

The following cleaning agents are known to affect the integrity of polycarbonate components and should not be

used:

- ZEP Fast 505, Pinesol, Formula 409

- Brake Cleaner

- Halogenated solvents (benzene, gasoline, acetone or carbon tetrachloride)

- Strong alkaline

- MEK (methyl ethyl ketone)

- Abrasive substances

Decommissioning

DANGER

Only remove the switch when deenergized (electrically and hydraulically/pneumatically).

Disconnection of the switch from pressure and power supply must be carried out by trained or

personnel according to state-of-the-art standards

WARNING

Be aware of the fact that in case of operation with higher temperatures the casing surface may become very

warm!

Software

ON -

Off

lock

OFF

instructed