Bobrick B-858 청소 및 유지 관리

{카테고리_이름} Bobrick B-858에 대한 청소 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Bobrick B-858 2 페이지. Automatic, counter-mounted soap dispenser
Bobrick B-858에 대해서도 마찬가지입니다: 문제 해결 매뉴얼 (3 페이지), 설치, 작동, 유지보수 지침 (2 페이지)

페이지 인쇄

Advisory Bulletin

TB-106

Cleaning and Maintenance For Bobrick B-850,

B-852, B-855, B-856 or B-858 Automatic

Counter-Mounted Soap Dispensers

Quality soap dispensers require good quality soap and periodic maintenance to properly operate. For reliable

long-term use, perform regular maintenance for each unit. Most soap dispenser problems are caused by soap

that is too thick or corrosive, or by a lack of maintenance. If proper soap is being used, problems can still

arise if dispensers have never been cleaned. Bobrick recommends a viscosity of 100 to19,000cP. With proper

maintenance and soap, Bobrick dispensers will provide long term, trouble free operation.

Deactivate the soap dispenser by placing your finger over the Fiber Optic Sensor area while you clean. The

sensor is located just behind the Nozzle Tip. Once dispenser is cleaned, remove finger from the sensor area. Or

un-plug the Power Supply located on the bottom of the housing (LED will not light).

Nozzle Tip

Fiber Optic

Sensor

Daily cleaning:

•

Using a soft, dry cloth wipe the exterior.

•

If dispenser is really dirty gently wipe the dispenser with a cloth moistened with warm water and a

diluted neutral detergent. Remove the detergent with a soft damp cloth and then rub with a second soft,

dry cloth.

Periodic cleaning

(3 to 6 months)

•

Remove Nozzle Tip and run under warm water.

•

To remove Nozzle Tip for cleaning, cover the Sensor area with your finger to prevent dispensing of soap.

Turn Nozzle to the left to loosen. Rinse Nozzle under hot water to loosen any soap residue and replace.

Turn Nozzle to the right to tighten

Nozzle Tip

DO NOT use abrasive or chemical cleaners (including chlorine bleach) to clean Spout, as it may dull the luster and attack the

chrome-plated exterior. Use ONLY mild soap and water, then wipe dr y with clean cloth. While cleaning the bathroom counter top,

protect the Spout from any splattering of cleaner. Acids and cleaning fluids will discolor or remove chrome plating.

Turn nozzle

to left to

loosen

Issued 8/14/19