BobsCNC E3 문제 해결 매뉴얼
{카테고리_이름} BobsCNC E3에 대한 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BobsCNC E3 16 페이지. Cnc router engraver bearing and rail dust kit
BobsCNC E3에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (3 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. My Stepper Motors Are Running Backward
- 3. My Z Axis Is Not Homing Correctly
- 4. My E3 will Not Home Correctly (Diagnosing Home Switches)
- 5. My Firmware Does Not Seem to be Working
- 6. I Tried to Use Easel, Now My Machine Does Not Work Correctly
- 7. I Get and Error When I Run a G-Code File Made with F-Engrave
- 8. My Z Stepper Motor Wobbles Excessively
- 9. My Machine Seems to be Skipping some Commands
- 10. What Are the Alarm Code Descriptions
- 11. How Do I Change My Current Setting on the Stepper Motor Drivers
- 11. Setting the Current on the A4899 Stepper Motor Driver with a Volt Meter
- 11. Setting the Current on the A4899 Stepper Motor Driver Without a Volt Meter
- 12. The Dewalt Motor Shaft Came out During Assembly. (Dewalt Brush Remove and Replace)
Simple Cost Effective Designs.
E3 CNC Router Troubleshooting Guide
The purpose of this document is to give those new to CNC routing is a quick reference for the common
issues of getting the E3 CNC router up and running.
This guide is not complete.
Please check back from time to time. We plan
to continue to add to help you get started.
Contents
My stepper motors are running backward. .................................................................................................. 2
My Z axis is not homing correctly ................................................................................................................. 2
My E3 will not home correctly (diagnosing home switches) ........................................................................ 4
My firmware does not seem to be working .................................................................................................. 5
I tried to use Easel, now my machine does not work correctly. ................................................................... 5
I get and error when I run a g-code file made with F-engrave ..................................................................... 5
My Z stepper motor wobbles excessively ..................................................................................................... 6
My machine seems to be skipping some commands ................................................................................... 6
What are the alarm code descriptions? ........................................................................................................ 7
How do I change my current setting on the stepper motor drivers? ........................................................... 8
Setting the current on the A4899 stepper motor driver with a volt meter. ............................................. 9
Setting the current on the A4899 stepper motor driver without a volt meter. ..................................... 10
The DeWalt motor shaft came out during assembly. ( DeWalt brush remove and replace) ..................... 10