Euro-Pro Shark SC620S 소유자 매뉴얼 - 페이지 9
{카테고리_이름} Euro-Pro Shark SC620S에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Euro-Pro Shark SC620S 13 페이지. Professional garment steamer 120v., 60 hz, 1500 watts
페이지 인쇄FAMILIARISEZ-VOUS AVEC VOTRE PRESSEUR DE
VÊTEMENTS À VAPEUR
1.
Crochet à vêtement
2.
Rallonges de crochet
à vêtement
3.
Levier de verrouillage
4.
Réservoir d'eau
5.
Roues
6.
Roulette avant
7.
Témoin d'alimentation (vert)
8.
Bouton de mise en marche
9.
Boyau à vapeur
10. Distributeur de vapeur
ou poignée
11. Tête à vapeur
12. Brosse à vêtements
13. Cordon d'alimentation (pas illustré)
Spécifications techniques
Tension :
120 V, 60 Hz
Intensité :
1500 watts
Capacité :
170 onces (US) (5 litres)
Température de vapeur max. : 220°F (105°C)
14
OPERATING INSTRUCTIONS cont.
Preparing Garment
Steamer for Use
CAUTION:
Before filling the water
tank, check to make sure that the
water tank sits securely in the unit
before proceeding.
Step 1: Preparing for Use
1.
Unwind the power cord.
2.
Check the wheels to see that they
swivel and roll properly.
3.
Set the unit on the floor and remove
the water tank. Check for sediment or
build-up in the base of the unit reservoir
and water tank. Follow steps for
cleaning and storing the unit if water
was accidentally left in the water tank
during storage of the unit on page 8.
4.
Place the steamer hose with the
nozzle end up on the garment
hook.(See fig. 7)
Fig. 7
5.
Make sure that the hose is and
unencumbered and that the unit rolls
freely.
IMPORTANT:
Do NOT add cleaning
solutions, scented perfumes, oils or any
other chemicals to the water used in this
appliance. Use tap water or
distilled/purified water if the tap water
in your area is very hard.
1.
Always make sure that the
appliance is unplugged before filling
the water bottle.
2.
To open the cap on the water bottle,
turn counterclockwise. Fill the water
bottle with tap water or
distilled/purified water if your tap
water in your are is very hard.
(See fig. 8)
3.
After filling the water bottle, close the
cap clockwise. (See fig. 8)
Fig. 8
4.
Replace the water tank into the unit.
(See fig. 9)
Fig. 9
Step 3: Using Garment Steamer
Note:
It will make pressing easier if
there are few creases in the laundry
that needs pressing. To avoid excess
creasing, shake each item out before
placing in a drier or hanging to dry.
1. Always check that the On/Off
button is in the "Off" position.
2. Plug appliance into electrical
outlet.
3. Push the "On/Off" button to the
"On" position. The power "On"
light (green) will come on.
7