Euro-Pro GI460 W 사용 및 관리 지침 매뉴얼 - 페이지 4

{카테고리_이름} Euro-Pro GI460 W에 대한 사용 및 관리 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Euro-Pro GI460 W 6 페이지. Garment steamer/iron 115/120v., 60 hz., 230/240 v., 50 hz. 800 watts/870 watts

페이지 인쇄

BEFORE FIRST USE

Remove any labels, stickers or tags which may be attached to the body or

soleplate of the garment steamer/iron before using the appliance.

Read all instructions for use carefully. Always follow the Important Safeguards.

IMPORTANT

The first time an iron is used, some odor and small white particles may come

out of the steam vents. This perfectly normal and will cease to occur after the

iron has been in use for a short while

Before you start using your garment steamer/iron, follow the instructions in the

manual and do the following in order to eliminate any odor and small white

residue particles and to ensure optimum steam performance.

• Fill the garment steamer/iron with regular tap water.

• Set the temperature control dial to its highest setting.

• The pilot light will go off to indicate that the garment steamer/iron has

reached the selected temperature.

• Keep the iron in a horizontal position and allow it to steam until the water runs

out.

• Press the steam trigger to eliminate white residue particles.

• Repeat this procedure through 2 or 3 fillings.

OPERATING INSTRUCTIONS

Before using your iron, check the

voltage and type of plug that is

required for your location. If

necessary, readjust the dual voltage

switch according to local voltage -

115/120V, 60 Hz., 230/240V, 50 Hz.

This is accomplished by sliding the

dual voltage control switch located in

the rear of the iron to the

corresponding voltage setting.

Note: The voltage selector is preset

at the factory for use on 115/120V,

60 Hz. N. A. household current.

Caution:

Always disconnect the iron before adjusting the dual voltage

switch to the correct voltage setting.

IRONING CHART

NOTE:

Before starting to iron or steam

delicate fabrics, it is best to first test the

temperature of the garment steamer/iron

on a hem or an inside seam.

DIRECTIONS

ON LABEL

SYNTHETIC

FIBERS, e.g.

acrylic, nylon

FABRIC

polyester

TEMP.

CONTROL

BURST OF

STEAM

Set temperature

to "MAX"

To select garment steamer/iron

temperature, align temperature

selected on dial with the indicator

on the water tank.

SILK

COTTON

WOOL

LINEN

MIN

MAX

• • • • •

•