Canon EOS 1D Mark III 백서 - 페이지 17

{카테고리_이름} Canon EOS 1D Mark III에 대한 백서을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon EOS 1D Mark III 38 페이지. Full line product guide
Canon EOS 1D Mark III에 대해서도 마찬가지입니다: 설치 매뉴얼 (2 페이지), 제품 설명서 (39 페이지), 제품 설명서 (36 페이지), 추가 기능 (6 페이지)

페이지 인쇄

Having the same drive mechanism as the EOS-1D Mark III, the EOS-1Ds Mark III's maxi-

mum continuous shooting speed is 5 fps in both the One-Shot AF and AI SERVO AF

modes. This rate is achieved with 8-channel reading, DDR-SDRAM (twice the capacity of

the EOS-1Ds Mark II's), and Dual "DIGIC III" Image Processors. Continuous shooting

speed can also be adjusted with C.Fn III-16 [Continuous shooting speed] as follows:

High-speed continuous within 2 to 5 fps, and low-speed continuous within 1 to 4 fps.

Metering and

The metering optics have the metering lens and 63-zone metering

Exposure Control

sensor positioned at the rear of the pentaprism. The 19 AF points in

the Area AF optimally match the metering sensor's zones.

The same 4 metering modes as in the EOS-1D Mark III are provided.

Metering Sensor

Partial metering covers about 8.5% of the viewfinder area at the

center, and spot metering about 2.4% at the center.

Because the metering area within the viewfinder is smaller than that of the EOS-1D Mark III,

the algorithm has been optimized for the EOS-1Ds Mark III. However, the basic algorithm

is the same as the EOS-1D Mark III's.

Metering Zones

Evaluative/Center-weighted

Partial metering

Spot metering

average metering

* C.Fn I -7-1 enables AF point-linked spot metering.

ISO bracketing is not provided in either the EOS-1Ds Mark III or the EOS-1D Mark III.

With the Ec-A, Ec-B, Ec-I, and Ec-L interchangeable focusing screens, only spot metering

outside the center and center-weighted average metering is possible. Since the prism

centers of these focusing screens are plainly transparent, an error will occur with evalua-

tive metering, partial, and center spot metering.

Custom Functions

The Custom Functions are the same as the EOS-1D Mark III's. The Custom Function

names, settings, numbers and so forth are the same. The only exceptions are C.Fn I-3

[Set ISO speed range], C.Fn I-8-2 [Safety shift: Enable (ISO speed)], C.Fn I-15-1 [Flash

sync. speed in Av mode: 1/250 sec.], and C.Fn III-16 [Continuous shooting speed]. Either

the setting values or control values have been changed to suit the EOS-1Ds Mark III's

specifications.

IV. DISCUSSION OF NEW AND IMPROVED FEATURES