Boca Systems Complete IDE Series 매뉴얼 - 페이지 9

{카테고리_이름} Boca Systems Complete IDE Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Boca Systems Complete IDE Series 17 페이지.

Section Three: Installation

Follow the directions below to physically install the IDE100 in

your system.

1. Power down the computer and remove the cover from the

system.

2. Select an empty expansion slot and remove the retaining screw

and dust cover. Firmly insert the IDE100 card, securing it with

the retaining screw.

NOTE: Depending on your system layout and preferences, it may be

easier to attach drive and LED cables before inserting the IDE100 into

the slot on the system board.

3. Attach the Drive Activity LED cable to the J3 connector. Attach

one end of the 40-pin cable to the hard disk drive in the system

and the other end to the J1 connector on the IDE100. When

connecting and configuring a second hard drive, refer to the

manufacturer's documentation.

4. Attach one end of the 34-pin cable to the floppy drive in the

system and the other end to the J2 connector on the IDE100.

NOTE: When connecting cables, be sure that Pin 1 on the cable,

marked with a colored stripe (often red), matches up with pin 1 on the

board connector.

Installation