Air cat 6525-ABS 사용 설명서, 부품 목록 및 보증 - 페이지 2
{카테고리_이름} Air cat 6525-ABS에 대한 사용 설명서, 부품 목록 및 보증을 온라인으로 검색하거나 PDF를 다운로드하세요. Air cat 6525-ABS 4 페이지. 1/4 x 18 -in. belt sander
페이지 인쇄Important Warnings - Sanders & Polishers
1. Eye protection, safety gloves and safety aprons must always we worn when operating a sander or
polisher.
2. Never adjust the sander or polisher or change the backing pad, sanding disc, sanding belt or
polishing bonnet unless the air supply and air hose is disconnected from the tool
3. Only use backing pads and polishing backing pads that have a rated speed then same as the sander
or polisher or higher.
4. Never attempt to modify or adapt a sander or polisher for use with a grinding wheel or cut-off wheel
or wire brush.
5. Only personnel trained in the correct methods to change pads, sanding discs, sanding belts and
polishing bonnets should conduct these operations.
SPECIFICATIONS
Free Speed
Model No.
(RPM)
6525-ABS
20,000
Air Supply
Tools of this class operate on a wide range of air pressure. It is recommended that air pressure of these tools measures 90 PSI at the tool while running free. Higher
pressure and unclean air will shorten the tool's life because of faster wear and may create a hazardous condition and void the warranty. Water in the air line will
cause damage to the tool. Drain the air tank daily. Clean the air inlet lter screen on at least a weekly schedule. The recommended hookup procedure can be viewed
in the illustration below. The air inlet, used for connecting air supply, has standard 1/4" NPT /BSP Thread. Line pressure should be increased to compensate for
unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D. and ttings should have the same inside dimensions.
Square
Belt Size
Motor
Drive
(HP)
(in.)
(in.)
0.6
1/4 x 18
Max. Torque
Weight
Gears
Minute
(ft-lb) @90 psi
(lbs.)
Direct Drive
2.6
Rec. Hose
Weight
Length
Air Cons.
Length
Air Cons.
Size
(in)
(lbs.)
(CFM)
(in)
(in.)
15.4
6
Rec. Hose
Air Inlet
Size
(CFM)
(in.)
3/8
1/4 NPT/BSP