Air cat 1680-A 운영 지침 - 페이지 2

{카테고리_이름} Air cat 1680-A에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Air cat 1680-A 4 페이지. 3/4" impact wrench

Important Warnings - Impacts

1. Eye protection and hearing protection and safety gloves must always be worn when operating an impact wrench or impact

driver.

2. When using heavy impact sockets or sockets on impact wrenches with 3/4" drive anvils or larger, a socket retaining ring

and pin should be used to prevent the socket falling off and causing injury.

3. Use only impact sockets and accessories. Only use sockets designated "FOR USE WITH IMPACT WRENCHES", hand tool

damage and replace when necessary.

Accessory Hazards

4. Disconnect the assembly power tool for threaded fasteners from the energy supply before changing the inserted tool or

accessory.

5. Do not touch sockets or accessories during impacting as this increases the risk of cuts, burns or vibration injuries.

6. Use only sizes and types of accessories and consumables that are recommended by the assembly power tool for threaded

fasteners manufacturer; do not use other types or sizes of accessories and consumables.

SPECIFICATIONS

Free Speed

Bolt Capacity

Model No.

(RPM)

1680-A

4,500

1680-6-A

4,500

Air Supply

Tools of this class operate on a wide range of air pressure. It is recommended that air pressure of these tools measures 90 PSI at the tool while running free. Higher

pressure and unclean air will shorten the tool's life because of faster wear and may create a hazardous condition and void the warranty. Water in the air line will

cause damage to the tool. Drain the air tank daily. Clean the air inlet lter screen on at least a weekly schedule. The recommended hookup procedure can be viewed

in the illustration below. The air inlet, used for connecting air supply, has standard 1/4" NPT American Thread or British Standard Pipe. Line pressure should be

increased to compensate for unusually long air hoses (over 25 feet). Minimum hose diameter should be 3/8" I.D. and ttings should have the same inside dimensions.

Square Drive

Impacts Per

(in.)

Minute

3/4

3/4 X 6

Max. Torque

Weight

(ft-lb) @90

(lbs.)

psi

950

1600

12.5

950

1600

14.8

Rec. Hose

Length

Air Cons.

Size

(in)

(CFM)

(in.)

8.9

1/2

14.8

1/2

Air Inlet

(in.)

NPT/BSP

3/8