American Standard 1340.865 설치 지침 - 페이지 3

{카테고리_이름} American Standard 1340.865에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard 1340.865 4 페이지. American standard metering spread lavatory faucet specification sheet

페이지 인쇄

INSTALL HANDLES

Remove INDEX BUTTON (1; 2) and loosen SET

SCREW (3) with a 2.5mm hex wrench.

Install HANDLES (4) onto VALVE STEM (5).

Tighten SET SCREWS (3) with 2.5mm Hex Wrench.

Replace INDEX BUTTONS. Red (1) in Left HANDLE (4)

Blue (2) in Right HANDLE (4).

TEST INSTALLED FITTING

Turn on water supplies and check connections for leaks.

Remove AERATOR (1) with KEY (2) supplied.

Operate HOT and COLD HANDLES by pressing down on HANDLES.

Both Hot and Cold handles are set for approximately 8 second operating cycles.

Replace AERATOR (1).

TO ADJUST CYCLE TIME

Remove HANDLE (1) by removing INDEX BUTTON (2)

and SET SCREW (3) with a 2.5mm hex wrench.

Pull off HANDLE (1).

To increase cycle time, turn the gray PLASTIC ADJUSTING

KNOB (4) clockwise.

To decrease cycle time, turn the gray PLASTIC

ADJUSTING KNOB (4) counter-clockwise.

Replace SET SCREW (3), INDEX BUTTON (2) and

HANDLE (1). Test faucet for proper operation and

cycle time.

2.5mm HEX WRENCH

TO INCREASE

TO DECREASE

CYCLE TIME

ROTATE

COUNTER-

CLOCKWISE

CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR

WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH,

ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A

COARSE SURFACE.

PRESS HANDLE

DOWN TO OPERATE

SERVICE

Remove HANDLE (1). Refer to Step 4 for handle removal.

Remove ACTUATOR ASSEMBLY (2).

Remove WASHER (3). Pull out VALVE ASSEMBLY (4) and

FILTER SCREEN (5).

Inspect that VALVE ASSEMBLY (4), FILTER SCREEN (5) and

VALVE SEAT (6) are clean and free from debris. VALVE

ASSEMBLY (3) and FILTER SCREEN (5) can be cleaned with

soap and water.

Replace FILTER SCREEN (5) and VALVE ASSEMBLY (4). Place

WASHER (3) on top of VALVE ASSEMBLY (4). Thread VALVE

ACTUATOR (2) onto faucet. Torque VALVE ACTUATOR (2)

to 12-15 ft. lbs (15-20 Nm).

Replace HANDLE (1).

REMOVE

2.5mm

HEX WRENCH

REPLACE

968492