Domus BLAST-48 설치 매뉴얼 - 페이지 14
{카테고리_이름} Domus BLAST-48에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Domus BLAST-48 16 페이지.
페이지 인쇄Checklist
Electricians make sure everything on this checklist is ticked off before you leave the installation site. If you have trouble installing our
product please refer to the trouble shooting section on page 13 first then phone Domus Lighting on (02) 9554 9600 (open 9am to
5pm EST on Monday to Friday). DO NOT uninstall the fan unless asked to do so.
1
Ceiling fan is not installed using a solid-state wall controller. Neither leading nor lagging edge controllers will give satisfactory
performance. Wall controllers must only be types approved for use by Domus Lighting.
2
The fan, fan light assembly and bracket are earthed.
3
Fan, fan light and remote control receiver are run from the same final circuit via an isolation switch.
4
Mounting bracket must be firmly secured to a solid structure such as a concrete ceiling, steel structure or timber framing.
If additional bracing is added it must be firmly secured to the rafters and not left floating on the ceiling. Special mounts, such
as T-hooks, are available for certain types of installation.
5
Counter sunk screws are not to be used to attach bracket to ceiling.
6
Fan blades are at least 2.1m (7 feet) above floor level.
7
Check the fan is operating correctly on all speeds.
8
If light is installed. Check light is functioning properly.
9
If remote control is installed. Check the fan (and light if installed) is responding to the remote control correctly. (Non-dimming
remote control to be used with fluorescent and LED lamps).
10 Check electrician's details have been recorded onto page 21 of this manual.
POWER OUTLETS OR FIXED WIRING MUST BE INSTALLED BY A LICENSED ELECTRICIAN
To protect your customer's WARRANTY please READ PAGE 2 of this booklet prior to the installation of this product.
14
Installation Manual
Date: December 4, 2023 3:32 pm