American Standard Bordeaux 9532.495 조립/설치 지침 - 페이지 2

{카테고리_이름} American Standard Bordeaux 9532.495에 대한 조립/설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard Bordeaux 9532.495 4 페이지. 32" vanity with wood top

페이지 인쇄

VANITY INSTALLATION

Provide suitable reinforcement required for anchoring the vanity to the wall. Centerline of reinforcement should be 32-

3/4" up from the floor (see Figure 1).

The molding needs to be notched to seat the vanity flush against the wall (see Figure 2).

Rough in supply lines and waste per rough in dimensions.

NOTE: If current supply lines are greater than 6" on center, they may interfere with cutout in rear of vanity or vanity shelf.

Remove the wood top from the vanity. The top is held in place from the underside by 4 screws, 1 through each of the 4

angled corner braces.

Move the vanity into place and anchor it to the wall through at least 2 of the anchoring holes in the rear of the vanity (see

Figure 2).

Continue with installation appropriate for top and sink options chosen.

C/L of 2 x 6

Reinforcement

32-3/4"

FIGURE 1

Finished

Floor

Wood Top with Recommended Sinks...

Two people recommended for this installation

Determine which sink is being installed and follow the instructions printed on the

appropriate template supplied with vanity.

NOTE: American Standard is not responsible for cut-out errors when the

incorrect cut-out template is used.

If Installing:

Use Template:

Sebring 0573

730541-400

Coventry 0575

730542-400

After top is replaced, connect the trap to the drain assembly hand tight to check

alignment. It may be necessary to cut off part of the tailpiece (area "A") or part

horizontal leg of the trap (area "B").

Connect hot and cold supply lines to the shut off valves. Tighten trap joints for

watertight assembly.

FIGURE 2

WOOD VANITY TOP

IMPORTANT: BE SURE TO CENTER SINK

CUT OUT HORIZONTALLY ON VANITY TOP.

- 2 -

21-1/4"

540mm

ANCHORING

HOLES

MOLDING

PAPER TEMPLATE

73 0 5 4 8 - 1 0 0 R e v. B

32-3/4"

832mm