American Standard Brook 9373.100 조립/설치 지침 - 페이지 2

{카테고리_이름} American Standard Brook 9373.100에 대한 조립/설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard Brook 9373.100 4 페이지. Brook console table

CONSOLE TABLE INSTALLATION

Choose a location that provides enough clearance for side doors to open freely.

Provide suitable reinforcement required for anchoring the vanity to the wall. Centerline of reinforcement should be 31-

3/4" up from the floor (see Figure 1).

The molding needs to be notched to seat the vanity flush against the wall (see Figure 2).

Rough in supply lines and waste per rough in dimensions.

Drill at least two 3/8" O.D. anchoring holes through the centerline of the rear stringer of the console table. The centerline

is located 1-1/2" down from the top of the table (see Figure 2).

Move the vanity into place and level with the adjustable glides on the bottom of the feet. The glides can be adjusted

outward up to 1" but it is recommended not to exceed 1/2" if possible. Anchor it to the wall through at least 2 of the

anchoring holes in the rear of the vanity (see Figure 2).

Continue with installation appropriate for top and sink options chosen.

C/L of 2 x 6

Reinforcement

31-3/4"

FIGURE 1

Finished

Floor

Wood Top 9474.670 with Morning 0670 / Loft 0660

Two people recommended for this installation

Wood top is already cut out to accept the Morning Loft / Sink.

Mount the drain assembly on the sink. Be certain to apply a bead of sealing putty

on the underside of the drain in order to ensure a watertight seal between the sink

and drain. Remove excess putty.

Install the faucet on the sink per the manufacturer's instructions. Install the sink on

the wood top using sealant. Add or remove excess compound around the base of

the sink rim. Form fillet the sealant with wet finger or a sponge.

Position the wood top on the console table and secure the top with the 6 screws

provided. Secure the wood top through the 6 brackets that are preinstalled on the

console table.

FIGURE 2

ADJUSTABLE GLIDES

(LOCATED UNDER

EACH FOOT)

- 2 -

19-1/4"

489m

1-1/2"

38mm

ANCHORING

HOLES IN

REAR STRINGER

MOLDING

73 0 5 5 1 - 1 0 0 R e v. C