Domus 66005 설치 매뉴얼 - 페이지 2

{카테고리_이름} Domus 66005에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Domus 66005 2 페이지.

Surface Mounted

3 Fix the batten base onto the required place

with screws.

5.Fasten terminal A between driver and LED MODULE；Snap LED MODULE back to BATTEN BASE;

Make sure all Spring Connector A are in place to securely hold LED MODULE to BATTEN BASE.

7.Turn on the power supply.

Suspended

Warning:

If the product is not installed as per the Installation Manual, then the warranty and liability for the product will

be voided.

Note:

-The lamp must be installed by professional electrician

-Ensure the power supply is switched off before fitting this product

4.Individually connect the Live wire,Neutral wire and Earth wire into the terminal block; Set the driver switch

to desired setting,and default driver setting is "I" mode.

Spring Connector A

Dual Power Switch:

I-High power

O-Low Power

29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia

Phone: 02 9554 9600

Terminal A

-Do not touch the lamp when in use

-Keep away from hot steam and corrosive gas

Terminal block

Fax: 02 9554 9433

www.domuslighting.com

Installation Manual

spring connector B

6.Push caps back to Batten

Base until it catch the spring connector B .