American Standard Claridge Centerset Lavatory Faucet 6054.XXX 설치 지침 매뉴얼 - 페이지 4
{카테고리_이름} American Standard Claridge Centerset Lavatory Faucet 6054.XXX에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard Claridge Centerset Lavatory Faucet 6054.XXX 7 페이지. Centerset lavatory faucet with the speed connect drain
페이지 인쇄
9
TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3). Turn counter-clockwise to remove.
Operate both HANDLES (1) to flush water lines thoroughly.
Replace AERATOR (3). Turn clockwise to install.
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (4) and fill lavatory with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in SINK. If DRAIN STOPPER (5)
does not seal properly, please refer to Troubleshooting
section in these instructions.
Release POP-UP KNOB (5) down and check all drain
connections and "P" trap for leaks.
if necessary.
10
SERVICE
To change direction of handle rotation, proceed as follows:
Turn Hot and Cold supplies off to faucet.
Turn HANDLES to OFF position.
Remove PLUG BUTTONS (1) on either side of ESCUTCHEON (2).
Loosen SET SEREWS (3) with 2.5mm hex wrench.
Pull SPOUT up while rotating side to side and remove
SPOUT & HANDLE (4) assembly to expose VALVES (7).
Remove SPRING CLIP (5) from valve .
Lift STOP WASHER (6), turn 90˚ and replace.
Replace SPRING CLIP (5).
Align SPOUT & HANDLE (4) assembly and install onto valve body.
When handles and spout are properly seated and aligned tighten
SET SCREWS (3) and replace PLUG BUTTONS (1).
AERATOR (8) may accumulate dirt causing distorted and reduced water flow.
Remove AERATOR (8) and rinse clean. Turn counter-clockwise to remove.
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90˚.
11
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
4
1
Tighten
2
6
4
5
WASTE
OUTLET
4
90˚
5
7
1
2.5mm
Hex wrench
1
3
2
"P" TRAP
3
2
M 9 6 8 6 3 2
8