Domus CHAM-TOUCH-3C 작동 지침
{카테고리_이름} Domus CHAM-TOUCH-3C에 대한 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Domus CHAM-TOUCH-3C 3 페이지. 3ch wall controller
CHAM-TOUCH-3C
Variant
Item No.
20144
CHAM-TOUCH-3C
Thank you for purchasing your new CHAM-TOUCH-3C Wall Controller, Please take the time to read and understand the instruction
sheet below. Failure to do so may void warranty.
Specifications
Type of controller:
RGBW touch wall control
Output signal:
RF + Bluetooth
Dimming range:
0.1% - 100%
Colour:
White (Glass)
Dimensions (mm):
(L) 120mm x (W) 75mm x (D) 29.1mm Operation voltage:
• Touch sensitive
• Glass interface(white & black)
• Compatible with all universal series RF+Bluetooth receivers
• Radio frequency: 2.4GHz
• Control RGBW colour
• Control 1 zone/area
• Waterproof grade: IP20
Function Introduction
Red channel: Click to turn off/on Press and hold
down to increase/decrease light intensity
Touch colour wheel, touch to select R/G/B colour
Blue channel: Click to turn off/on Press and hold
down to increase/decrease light intensity
Click to select Warm White, Natural White and
Cool White mixed by RGB colours
Press and hold down to
increase/decrease light intensity
Note:
-The lamp must be installed by professional electrician
-Ensure the power supply is switched off before fitting this product
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
[email protected] | www.domuslighting.com.au
Detail
3CH Wall Controller
Cutout (mm):
Transmission frequency:
Operating temperature:
Power consumption:
Safety & Warnings
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
-Do not touch the lamp when in use
-Keep away from hot steam and corrosive gas
Phone: 02 9554 9600 | Fax: 02 9554 9433
Installation Manual
(L) 70mm x (W) 44mm x (D) 20mm
2.4GHz
0-40°C
< 15mA
240V
Green channel: Click to turn off/on Press and
hold down to increase/decrease light intensity
White channel: Click to turn off/on Press and
hold down to increase/decrease light intensity
Click to switch on/off
Click to play / pause the 10 built-in effects, Press
and hold down to speed up/down the running effects
Press and hold down to save colour/effect;
Click to recall the saved
Date: May 19, 2022 12:19 PM