DOMUS LINE ATOM D-M 설치 매뉴얼 - 페이지 6

{카테고리_이름} DOMUS LINE ATOM D-M에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOMUS LINE ATOM D-M 14 페이지.

INSTALLATION MANUAL

CONNECTING THE DEVICE TO THE POWER SUPPLY _ Tunable

White dynamic light configuration D-MOTION fig.7

- Connect the ATOM D-M power supply cable to one of the light

colour dynamic adjustment systems D-MOTION sold separately and

with power at least 10% greater than the total load. For the total

load calculation check plate data printed on the product label.

- For installation and operation of the light colour dynamic

adjustment system see the specific item's manual.

- Then connect the light colour dynamic adjustment system to a

safe power supply with 24Vdc stabilised voltage (sold separately)

and with power at least 10% higher than the total load. For the

total load calculation check plate data printed on the product label.

- If more than one device must be connected to the power supply

unit ensure that the total sum of the power absorbed by the

devices (check the plate data shown on the product label) does not

exceed the maximum power permitted both by the dynamic

adjustment system and by the Converter.

WARNING:

The Led MODULE, the power supply cable or any switch used,

are not replaceable, therefore in case of damage the device

must be entirely substituted.

WARRANTY

DOMUS Line guarantees the product only if powered with a

Converter supplied by us.

The warranty's general terms and conditions for this device are

available at www.domusline.com

CAUTION

ONLY SUITABLE FOR DRY LOCATION

CABINET USE ONLY

USE ONLY 24Vdc CLASS 2 POWER SUPPPLY

TYPE IC RECESSED – INHERENTLY PROTECTED

TO REDUCE THE RISK OF FIRE DO NOT INSTALL CLOSER THAN

10mm TO THE CABINET WALL OR IN A COMPARTMENT SMALLER

THAN 300mm BY 300mm