American Standard Enfield Console Table 7460.200 조립 및 설치 지침 - 페이지 2

{카테고리_이름} American Standard Enfield Console Table 7460.200에 대한 조립 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard Enfield Console Table 7460.200 4 페이지. Enfield console table with raised wood panels with cast grilles

페이지 인쇄

CONSOLE TABLE INSTALLATION

Identify desired location of the console table.

Provide suitable reinforcement required for anchoring the vanity to the wall. Centerline of reinforcement should be 30" up

from the floor (see Figure 1).

Rough in supply lines and waste per rough in dimensions.

Drill at least two 3/8" O.D. anchoring holes through the rear stringer of the console table at 2-1/2" down from the top of

the table (see Figure 2).

Move the vanity into place and level with the adjustable glides on the bottom of the feet. The glides can be adjusted

outward up to 3/8". Anchor it to the wall through the 2 anchoring holes in the rear of the vanity (see Figure 2). Do not

overtighten to prevent cracking the rear stringer.

C/L of 2 x 6

Reinforcement

30"

762mm

FIGURE 1

Finished

Floor

VANITY TOP, SINK, AND FAUCET INSTALLATION

Install the faucet onto the granite top per the manufacturer's instructions.

Two people recommended for this installation

Apply a continuous 1/8" bead of silicone

sealant 1" from the inside edge of the

console. Carefully set the stone top on the

console table. Be sure that the top is

centered on the table.

Use mineral spirits to remove excess silicone from the console and stone top.

FIGURE 2

ADJUSTABLE

GLIDES

(LOCATED

UNDER

EACH FOOT)

- 2 -

19-1/4"

489mm

2-1/2"

64mm

3/8" ANCHORING

HOLES IN

REAR STRINGER

MOLDING

GRANITE TOP

SEALANT

7 5 2 8 7 7 - 1 0 0 R EV. A