DOMUS LINE LINEO 설치 매뉴얼 - 페이지 6
{카테고리_이름} DOMUS LINE LINEO에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOMUS LINE LINEO 15 페이지.
페이지 인쇄INSTALLATION MANUAL
- The output cable of LINEO TDM can handle a load
of max. 60W @ 24VDC included the absorption of
the device figure 4.
OPERATION LINEO SLAVE:
The LINEO SLAVE (F) is a switch-free spotlight, then it
must be turned on via a remote switch that can be
placed on the LINEO TDM (wired in the MASTER
version) as shown in figure 4 or it can be assigned to
a separate switch connected to the primary of the
converter as shown in figure 3, or to a remote socket
where to connect the converter.
ATTENTION:
LINEO
TDM must be connected directly
to the electronic feeder and it must not be
connected after other electronic switches.
The sensor must not be installed near
electromagnetic sources or heat sources .
WARNING:
The Led MODULE, the power supply cable or any
switch used, are not replaceable, therefore in case of
damage the device must be entirely substituted.
EN
WARRANTY:
The warranty on the device is valid only if powered
by a power supply provided by DOMUS Line. The
warranty's general terms and conditions for this
device are available at www.domusline.com