Domus Ventilation DX Series 설치 및 유지 관리 매뉴얼 - 페이지 3
{카테고리_이름} Domus Ventilation DX Series에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Domus Ventilation DX Series 8 페이지. Fan module 50hz/60hz
Domus Ventilation DX Series에 대해서도 마찬가지입니다: 설치 및 유지 관리 매뉴얼 (7 페이지), 설치 및 유지 관리 매뉴얼 (7 페이지)
페이지 인쇄
Installation and Maintenance
DX Window Fan Kit 50Hz/60Hz
9
9
Screw the case/ grille assembly together.
Screw the case/ grille assembly together.
11
11
For various wiring options see page 5.
For various wiring options see page 5.
13
13
Fit the inside grille, locating it over the top lip before
Fit the inside grille, locating it over the top lip before
engaging screws.
engaging screws.
4.2 Fitting Ancillaries (Also see page 8)
4.2 Fitting Ancillaries (Also see page 8)
4.2.1 Thin Wall Installation
4.2.1 Thin Wall Installation
The diagram shows the unit
The diagram shows the unit
installed in a timber wall.
installed in a timber wall.
A Wall Fixing Plate is used
A Wall Fixing Plate is used
to support the fan assembly
to support the fan assembly
and the installation is similar
and the installation is similar
to that for a window.
to that for a window.
LAB1350R May 2018
Outside
Outside
Grille
Grille
Interior
Grille
Spacer
Spacer
Wall
Wall
Fixing
Fixing
Plate
Plate
10
10
Release the electrical cover from the fan plate.
Release the electrical cover from the fan plate.
12
12
Assemble the fan plate to the case.
Assemble the fan plate to the case.
IMPORTANT
IMPORTANT
(Shutter Operation XS fans)
There will be a short delay on start-up and shutdown of
There will be a short delay on start-up and shutdown of
approximately 40 seconds, this is normal.
approximately 40 seconds, this is normal.
4.2.2 Weather Terminal
4.2.2 Weather Terminal
The optional Weather Terminal is offered for use in exposed site
The optional Weather Terminal is offered for use in exposed site
conditions.
conditions.
The illustration shows the Weather Terminal installed replacing the
The illustration shows the Weather Terminal installed replacing the
Outside Grille assembly. Terminal is held in position using the same
Outside Grille assembly. Terminal is held in position using the same
fixings as the Outside Grille assembly. The base of the Terminal
fixings as the Outside Grille assembly. The base of the Terminal
incorporates a foam strip which is designed to adhere to the
incorporates a foam strip which is designed to adhere to the
glass surface assisting fitting and also as a seal for the joint when
glass surface assisting fitting and also as a seal for the joint when
assembled together with the fan unit.
assembled together with the fan unit.
Interior
Grille
Weather
Weather
Terminal
Terminal
V E N T I L A T I O N
(Shutter Operation XS fans)
Glass
Glass
Main
Main
Window
Window
fan kit
fan kit
Page 3