Domus Ventilation DX6PR 설치 및 유지 관리 매뉴얼 - 페이지 6
{카테고리_이름} Domus Ventilation DX6PR에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Domus Ventilation DX6PR 7 페이지. Flat roof fan kit 50hz/60hz
페이지 인쇄
Installation and Maintenance
DX Flat Roof Fan Kit 50Hz/60Hz
5.5 F
6.5 Fitting Remote Controller DX-CON or
itting Remote Controller DX-CON or
Rem
ote sensors (optional)
Remote sensors (optional)
The DX-CON Multi Fan Control provides supply or extract, variable
The DX-CON Multi Fan Control provides supply or extract, variable
speed and automatic or manual switching of several fans if desired, (see
speed and automatic or manual switching of several fans if desired, (see
note below). The control is best mounted approx 1.5m above the floor.
note below). The control is best mounted approx 1.5m above the floor.
Remote Sensors are available for Humidity only. Remote Sensors should be
Remote Sensors are available for Humidity, Air Quality and Passive Infra
Red control. Remote Sensors should be positioned at least 1.5m above
positioned at least 1.5m above the floor and away from direct heat sources
e.g. radiators.
the floor and away from direct heat sources e.g. radiators.
Note:
Note:
Up to 5 fans (size 6 / 9 inch) can be controlled by one DX-CON.
Up to 5 fans (size 6 / 9 inch) can be controlled by one DX-CON.
Up to 2 fans (size 12 inch) can be controlled by one DX-CON.
Up to 2 fans (size 12 inch) can be controlled by one DX-CON.
Do n ot mix different fan sizes on the same controller.
Do not mix different fan sizes on the same controller.
2
2
Push out backplate box cable entry using a screwdriver.
Push out backplate box cable entry using a screwdriver.
4
4
Fix backplate box to the prepared wall.
Fix backplate box to the prepared wall.
6
6
Connect the end of the cable into the control block.
Connect the end of the cable into the control block.
LAB1347R May 2018
1
1
Lift up panel and remove two screws to dismantle unit.
Lift up panel and remove two screws to dismantle unit.
3
3
1.5m
1.5m
Spot through backplate box and drill and plug the wall.
Spot through backplate box and drill and plug the wall.
5
5
Feed approx. 200mm of supply cable into the box.
Feed approx. 200mm of supply cable into the box.
7
7
Fit the control into the backplate box and secure.
Fit the control into the backplate box and secure.
Test the installation.
Test the installation.
V E N T I L A T I O N
200mm
200mm
Page 6