16XEIGHT SD2IEC evo2 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} 16XEIGHT SD2IEC evo2에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 16XEIGHT SD2IEC evo2 8 페이지.

The DiskChange and Reset buttons can now be

installed, if desired, by using the supplied cable

and connecting the corresponding wires to the

CTRL interface on the SD2IEC board as shown

below.

Make sure that the unused wires are carefully

isolated to ensure that the no short circuits can

arise!

The optional LCD status display may now be installed in a suitable position.

Assembly of the device may be completed. Connect the power cable LED, CTRL interface and op-

tional LCD display to the appropriate connectors on the SD2IEC board.

Select the device address for the SD2IEC

using the dip switches located on the

SD2IEC circuit board. The following dia-

gram shows the corresponding device

number and switch positions.

(This can also later be permanently

changed directly from the C64)

When using an LCD status display, contrast adjustment must be made before refitting the case.

To do this, connect the C64 to the power supply and turn it on. Now, with a small screwdriver,

turn the contrast potentiometer on the SD2IEC circuit board until the display is easy to read.

You can now reassemble the C64 in reverse order and start commissioning the device.

DIP-Switch Positions for Device ID 8-11

-5-

Fig. 1.4

ID DIP 1 DIP 2

8 OFF

OFF

9 ON

OFF

10 OFF

11 ON

Fig. 1.5