American Standard 6030ST3 설치 지침 - 페이지 3

{카테고리_이름} American Standard 6030ST3에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard 6030ST3 4 페이지. Seated shower base

페이지 인쇄

A.) THIS SHOWER BASE MUST BE SUPPORTED ALONG IT'S ENTIRE BOTTOM. We recommend the use of

mortar as bedding material (sand is not recommended). Apply enough bedding to support the complete bottom of

the shower base. After the bedding has been poured, and before it sets, position the shower base within the recess

until the rim is leveled against the leveling stringers (see "Typical Recess Installation") shown below. The rim of the

shower base MUST NOT support weight. Allow the bedding material to completely harden before applying weight

to the rim or bottom of the shower base.

B.) Check level front to back and side to side, shim as necessary. To secure the shower base to wood studs, use

drywall screws with flatwashers or roofing nails immediately above the flange of the shower base. To secure the

shower base to steel studs, use 4" drywall screws and flatwashers.

WOOD

STUDS

WATERPROOF DRYWALL

C.) Any finish material such as tile or wallboard must be self-supporting if it contacts the deck of the shower base.

Flooring will be butted against the bottom of the shower base apron, also holding the shower base in place.

DRAIN CONNECTION

Using recommended drain opening, connect shower base drain to waste line. Tighten all drain joints securely.

TYPICAL RECESS INSTALLATION

60-3/16"

(1529mm)

TYPICAL FLANGE MOUNTING DETAIL

SUGGESTED SHOWER BASE

INSTALLATION METHOD

STUD

TILE

OR CEMENT BOARD

DRYWALL SCREW

OR ROOFING NAIL

SEALANT

SHOWER

BASE

1" x 3" (25 x 76mm) WOOD

STRINGER FULL LENGTH

SECURE THE SHOWER BASE TO THE STUDS AS SHOWN

FOR WOOD OR STEEL STUD CONSTRUCTION.

LEVELING

STRINGERS

STEEL