DOMUSA TEKNIK Sanit S 500 설치 및 운영 지침 매뉴얼 - 페이지 4

{카테고리_이름} DOMUSA TEKNIK Sanit S 500에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOMUSA TEKNIK Sanit S 500 20 페이지.

Sanit

1 PRECAUTIONS

Sanit hot water tanks must be installed by qualified staff in compliance with applicable

regulations.

Any work must be carried out by the official Technical Assistance Service, as any changes to its

configuration could cause functioning errors and could damage the system and its surrounding

environment.

This appliance can be used by children aged from 8 years and above and persons with reduced

physical, sensory or mental capabilities or lack o experience and knowledge if they have been

given supervision or instruction concerning use if the appliance in a safe way and understand th

hazards involve. Children shall not play with the appliance. Cleaning and user maintenance shall

not be made by children without supervision.

The electrical main power supply connection must respect the current legislation, making

possible a complete disconnection of the tank, in order to make any maintenance operation

safely. Look "Diagram and electrical connection" chapter.

The hydraulic installation must be made by qualified technicians, in compliance with the current

installation regulations.

When there is danger of frost, and particularly in areas with very low temperatures, precautions

will need to be taken to prevent damage to the installation. It is recommendable to add anti-

freeze to the water in the primary circuit of the tank. The anti-freeze used must be compatible

with public health regulations and it must not be toxic. DOMUSA TEKNIK recommends the use

of propylene glycol, consulting the product manufacturer before use.

If the installation is to be out of use for a long period, drain all the water from the tank.

The water must comply with the characteristics defined in the Technical Building Code, and

must be treated if necessary.

The water must be in accordance with Directive 98/83 / EC on the quality of water intended for

human consumption. Special attention must be paid to the following parameters:

- Maximum chloride concentration: 250 mg / l.

- Maximum sulphate concentration: 250 mg / l.

- Maximum concentration of chlorides and sulphates: 300 mg / l.

- Maximum conductivity: 800 µS / l.

When the chlorine concentration in the Domestic Water exceeds 250 mg / l., it is recommended

that anti-corrosion protection should be applied to the inside of the inter-accumulator so as to

avoid its premature deterioration. As an option DOMUSA TEKNIK supplies electronic cathodic

protection that is suitable for the Sanit inter-accumulator range. To install it, read carefully the

assembly instructions that are provided with the same.