American Standard DXV LYNDON D12536-014 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} American Standard DXV LYNDON D12536-014에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard DXV LYNDON D12536-014 8 페이지. 5-1/2' x 30", 5-1/2' x 33"

페이지 인쇄

GENERAL INSTALLATION INFORMATION

Carefully uncrate and inspect your new bath for any shipping damage. If such damage is found, report it to your

vendor immediately. After inspection and during installation, protect the bath from construction damage. Before

installation, and before enclosing with wallboard, tile, etc., the bath must be lled with water to check for leaks that

may have resulted from shipping damage or mishandling! Fittings (bath ller, shower arm, etc.) are not provided with

the bath and must be ordered separately. Framing and enclosing materials are provided by others. Follow test

procedures carefully.

THIS TUB MUST BE TESTED FOR OPERATION AND LEAKS PRIOR TO ENCLOSURE OF SURROUNDING

AREAS. FAILURE TO DO SO WILL VOID WARRANTY. THIS TUB WAS WATER TESTED AT THE FACTORY AND

FOUND TO BE FULLY OPERATIONAL AND LEAK FREE PRIOR TO SHIPPING. FREIGHT HANDLING AND JOB

SITE EXPOSURE MAY HAVE DETERIORATED THE TUB'S CONDITION. IT IS THE RESPONSIBILITY OF THE

INSTALLER TO THOROUGHLY TEST THE UNIT PRIOR TO INSTALLATION. TUBS ARE INTENDED FOR

INDOOR USE ONLY.

TEST PROCEDURES:

1. Place the tub on a at surface such as a driveway.

2. Seal the drain.

3. Fill tub and allow tub to stand for ve minutes. Examine all ttings carefully for leaks. NOTE: The over ow is a

plumbing device designed to prevent water from reaching a certain level in your tub. DO NOT, under any

circumstances, tape off or block the over ow in any way.

4. If any leaks or operating problems are discovered, do not complete installation until problems are

resolved. DXV by American Standard will not be responsible for any costs involved with removing or

reinstalling the tub, or for the costs of any surrounding materials or labor.

If you have installation or warranty questions please do not return the unit to the place of purchase. Call 800-227-2734.

Always protect tub from construction damage by using a protective cover. Damage, including chips and scratches

incurred at the jobsite is excluded from warranty but may be repaired by quali ed technician at the owner's expense.

Do not stand in the tub or store materials in the tub during construction. Do not store tub in temperatures below 32

degrees Fahrenheit.

Protect all nished surfaces of the bathtub during construction and installation using a drop cloth.

ATTENTION INSTALLER!

- 4 -

754988-100 REV. B (5/15)