American Standard Ellisse 2711.002 사양 시트 - 페이지 2
{카테고리_이름} American Standard Ellisse 2711.002에 대한 사양 시트을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard Ellisse 2711.002 2 페이지. 6' x 48" whirlpool and bathing pool high gloss
페이지 인쇄927mm
(36-1/2)
305mm
(12)
1219mm
(48)
GRAB BAR
RECOMMENDED
FITTING AREA
FITTING
LOCATION
DECK FITTING
64X279mm
2-1/2 X 11)
51mm
(2)
INTEGRAL
FEET
SUPPORT
1-1/2 N.P.T.M. THREADS
1-1/2 O.D.TAILPIECE
GENERAL SPECIFICATIONS FOR 2711 WHIRLPOOL
INSTALLED SIZE
72 x 48 x 21-1/2 In. (1829 x 1219 x 546mm)
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT
3
)
WHIRLPOOL ELECTRICAL SPECIFICATIONS
SYSTEM II PUMP
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE INSTALLATION. SUMP
OF BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIAL BY OTHERS.
■
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
OPTIONAL GRAB BAR KIT AVAILABLE AND MUST BE ORDERED SEPARATELY.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
●
IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH
CIRCULATING SYSTEM PIPING. MOUNTING HOLES DRILLED BY INSTALLER.
SUPPLY PIPING NOT INCLUDED.
ON SYSTEM II VARIATION: SYSTEM CONTROL MODULE TO BE MOUNTED BEHIND ACCESS PANEL A MINIMUM OF (152MM) 6"
ABOVE ROUGH FLOOR.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1.
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.
© 2008 AS America Inc.
1829mm
(72)
OUTLINE OF CUTOUT
1791 X 1181
(70-1/2 X 46-1/2)
229mm x 356mm
(9 x 14) FLOOR
CUTOUT
PROVIDE ACCESS
OPTIONAL
TO PUMP FOR SERVICE
ON ALL INSTALLATIONS
AREA
LEVELING STRINGER
SAFE-T-
(NOT FOR SUPPORT)
HEATER
REMOVABLE
C/L OF
BLANK
OVERFLOW
546mm
105mm
(21-1/2)
(4-1/8)
495mm
ROUGH
(19-1/2)
FLOOR
121mm
64mm
(4-3/4)
(2-1/2)
148 Lbs. (67 Kg.)
965 Lbs. (434 Kg.)
95 Gal. (360 L)
74 Gal. (280 L)
43 x 28 In. (1092 x 711mm)
68 x 38 In. (1727 x 965mm)
14-5/8 In. (371mm)
40 Lbs./Sq.Ft. (195 Kgs./Sq.m)
30.3
60.8
2.1 HP, 15.6 AMPS ,120V.
WHIRLPOOL AND BATHING POOL
102mm
(4)
305mm
(12)
C/L OF
DRAIN
1219mm
PUMP
(48)
RECOMMENDED
FITTING
LOCATION
64X279mm
2-1/2 X 11)
51mm
(2)
INTEGRAL
FEET
SUPPORT
GENERAL SPECIFICATIONS FOR 7211 BATHING POOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT
3
)
H48
ELLISSE™ 6' x 48"
1829mm
(72)
OUTLINE OF CUTOUT
927mm
1791 X 1181
(36-1/2)
(70-1/2 X 46-1/2)
229mm x 356mm
(9 x 14) FLOOR
CUTOUT
GRAB BAR
FITTING AREA
OPTIONAL
DECK FITTING
AREA
105mm
(4-1/8)
ROUGH
FLOOR
1-1/2 N.P.T.M. THREADS
1-1/2 O.D.TAILPIECE
64mm
(2-1/2)
72 x 48 x 21-1/2 In. (1829 x 1219 x 546mm)
43 x 28 In. (1092 x 711mm)
68 x 38 In. (1727 x 965 mm)
40 Lbs./Sq.Ft. (195 Kgs./Sq.m)
HIGH GLOSS
102mm
(4)
C/L OF
DRAIN
LEVELING STRINGER
(NOT FOR SUPPORT)
C/L OF
OVERFLOW
546mm
(21-1/2)
495mm
(19-1/2)
121mm
(4-3/4)
133 Lbs. (60 Kg.)
950 Lbs. (432 Kg.)
95 Gal. (360 L)
14-5/8 In. (371mm)
30.3
60.8
Revised 2/08