Air Cleaning Equipment Horizon Galaxy 설치 및 운영 매뉴얼 - 페이지 4
{카테고리_이름} Air Cleaning Equipment Horizon Galaxy에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Air Cleaning Equipment Horizon Galaxy 16 페이지. Horizon series
페이지 인쇄Installation:
The area to be controlled should be sealed with a vapor barrier. If unit is installed in a
crawlspace, all vents should be sealed.
WARNING
: It is recommended to remove dehumidifier from area if applying a liquid
vapor barrier. Some coatings dry via "solvent evaporation," which can be harmful to
certain components in your dehumidifier. Allow coating to completely dry and exhaust
vapors prior to positioning dehumidifier. Read and follow coating manufacturer's
instructions completely.
1) Place dehumidifier on level surface
WARNING
– If after unit is positioned,
the unit is moved in such a manner that the compressor didn't remain in a vertical
orientation, wait a minimum of 2 hours before turning the unit "on."
2) Drain Line
o Included drain line attaches to the unit via a compression type fitting on the
discharge end of the unit. Remove the compression nut and slide it over the
end of the hose to be attached to the unit. Slide that end of the tube over the
insert on the compression fitting completely. Tighten compression nut.
o Drain line should be routed to a suitable drain or outside. Drain line must
flow down to drain without any loops, dips or valleys.
3) Plug unit into 15 amp grounded outlet.
Drain Tube – 10' Long. 10 mm OD.
4