Domyos VE 460 사용 설명서 - 페이지 14
{카테고리_이름} Domyos VE 460에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Domyos VE 460 16 페이지. Eliptical cross trainer
Domyos VE 460에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지), 사용 설명서 (16 페이지), 사용 설명서 (16 페이지)
페이지 인쇄
E
Reminder: to enter programming mode, press on E for a long time
Use buttons A and C to increase and decrease the values.
Press down for a long time to make the values scroll faster.
Press on B to validate your selection and switch to the next parameter.
If you make a mistake, press on D to return to previous screens.
When you have finished programming, press on E to exit programming mode..
1. Remove the console from its base, take off the battery lid located
on the back of the product and insert two AA or UM-3 batteries
into the battery compartment behind the screen.
2. Make sure the batteries are installed correctly and that they are
flush with the springs.
3. Put the battery lid back on and check to ensure that it is secure.
4. If the display is illegible or partial, remove the batteries, wait
15 seconds and then put them back in.
5. If you remove the batteries, the computer memory is erased.
- If the counter is not indicating the right units of measure for distance,
check that the switch on the back of the console is in the Mi position for
a display in miles and in Km for a display in kilometers. Remove the
batteries and reinsert them to make the change take effect.
N
G
OPERATING DIAGRAM
INSTALLING BATTERIES
TROUBLESHOOTING
L
I
RECYCLING:
The "crossed-out wastebasket" symbol indicates that this product and the
batteries it contains cannot be thrown away with household waste. They are
subject to a specific type of sorting. Deposit the batteries and your end-of-life
electronic product in an authorized collection area for recycling. This treatment
of your electronic waste will protect the environment and your health.
- If the distance or speed is abnormal, check that the switch on the back
of the console is in the VM position for magnetic bikes and in VE position
for elliptical bikes.
On magnetic bikes, each pedal revolution corresponds to a distance of
4 meters / 13.12 feet, and on elliptical bikes, 2 movements correspond
to a distance of 1.6 meters / 5.25 feet (these values correspond to
average values when riding or walking).
- If the heart rate indicator (9) is not flashing or is flashing erratically,
check that your hands are positioned properly and that the sensors are
not too moist
If the counter does not turn on:
- verify that the batteries are in the right +/-position
If the problem persists:
- start over with new batteries
If the problem persists:
- check the condition and the connections of the cables on the back of the
console, and where the stem meets the main frame of the bike
If the problem persists:
- bring the product back to the nearest DECATHLON store
22
S
H