D3D D3DONEPRO 첫 번째 설정 매뉴얼 - 페이지 4

{카테고리_이름} D3D D3DONEPRO에 대한 첫 번째 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. D3D D3DONEPRO 6 페이지.

12: insert the spool holder in the dedicated position and rotate on your left to lock it in the right position

like photo.

13: mount the Bondtech feeder,please read the Bondtech manual pdf

14: hang the Bondtech feeder on the left side panel and connect the wires with FED external left panel

WARNING!! MAKE SURE YOU ONLY PULL ON THE CONNECTOR,NOT THE WIRES AND ALWAYS WITH 3D PRINTER is

ALWAYS OFF

15: insert filament in the Bondtech feeder pulling on the lever like photo

16: connect the power supply cable to the 3D Printer and switch it ON

17: Touch the LCD Screen, click on MENU then PREPARE and BED LEVEL.You will find all the informations on

how to use the lcd touch screen in the dedicated manual iop_102030ForFinalCustomers_V1-00.pdf

18: click on the touch screen to move the printer head and place it on an angle of your choice. adjust the

height of the head using the screws located under the level bed. you can place a sheet of paper in between

the bed and the nozzle to help you reaching a good height. renew this operation at three (3) different

points on the bed.