Da-Lite Large Cosmopolitan Electrol 지침서 - 페이지 6

{카테고리_이름} Da-Lite Large Cosmopolitan Electrol에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Da-Lite Large Cosmopolitan Electrol 8 페이지.
Da-Lite Large Cosmopolitan Electrol에 대해서도 마찬가지입니다: 지침서 (12 페이지)

페이지 인쇄

LARGE COSMOPOLITAN

CONTROL

240V WIRING DIAGRAM

WITH OPTIONAL BUILT-IN

LOW VOLTAGE CONTROL

BLUE (COMMON)

BROWN (HOT)

240VAC 50HZ

GREEN

GROUND–MUST BE

CONNECTED TO

BUILDING GROUND

ILT RJ9 PIN-OUTS

(TAB IS FACING UP)

IR or UP

BLACK

GND COMMON

RED

+5V

GREEN

DN or DATA

WHITE

SCREEN AdjUSTMENT FOR 240v SCREENS WITH A BUILT-IN LOW VOLTAGE CONTROL

1. Remove the cover plate from the 3-button wall switch and remove the switch from the junction box.

2. Locate small 3-position switch on back of wall switch. see figure 4 for 120v screens or figure 5 for 220/240v

screens.

3. To adjust the down limit switch, slide the 3-position switch to the down position. Press and hold the down button

to run the screen down to the desired stop position. Release the button to stop the screen. do noT Push ThE

sToP BuTTon.

4. when the screen is in the desired down position, slide the 3-position switch to the off (center) position. The down

limit switch is now set.

5. To adjust the up limit switch, slide the 3-position switch to the up position. Press and hold the up button to run the

screen up to the desired stop position. Release the button to stop the screen. do noT Push ThE sToP

BuTTon.

6. when the screen is in the desired up position, slide the 3-position switch to the off (center) position. The up limit

switch is now set.

7. To test limit switch setting, make sure the 3-position switch is in the off (center) position. Press and release the up

or down button on the wall switch to operate the screen.

8. Replace switch and cover plate on the wall.

NOTE: if stop button is pressed, the wall switch will reverse direction. To correct this, press the stop button again. This

will reset the switch. You will have to re-set both the up and the down settings.

IMPORTANT NOTE: The wall switch is REQuiREd to make any limit switch adjustments, EvEn if a third party control

system is used. Therefore, it is advised to wire the switch or provide a 4-conductor connection that is

accessible.

ELECTROL

INSTALLATION FOR 240V SCREENS WITH A BUILT-IN LOW VOLTAGE

GREEN

GROUND TO CASE

IMPORTANT NOTE: The wall switch is REQuiREd to make any limit

OPTIONAL IR AND RF

REMOTE CONTROL

MOTOR

RJ9

SPLITTER

DRY CONTACTS

switch adjustments, EvEn if a third party control

system is used. Therefore, it is advised to wire

the switch or provide a 4-conductor connection

that is accessible.

5 5

CONNECT SUPPLIED

RJ9 CABLE TO

SPLITTER AND

SWITCH, OR USE 4

CABLE CONDUCTOR

TO CONNECT TO

LOW-VOLTAGE WALL SWITCH

SCREW TERMINALS.

RJ9

STOP

DOWN

FRONT

FIGURE 5

UP DN

GND +5V

3-POSITION

RJ9

SWITCH

BACK