Da-Lite MULTI-MASK IMAGER 지침서 - 페이지 4
{카테고리_이름} Da-Lite MULTI-MASK IMAGER에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Da-Lite MULTI-MASK IMAGER 8 페이지.
Da-Lite MULTI-MASK IMAGER에 대해서도 마찬가지입니다: 지침서 (12 페이지)
페이지 인쇄Multi-Mask Imager Installation
Installing the High Voltage Switch Control (Standard)
Three standard 3-position wall switches are supplied. The high-voltage control is connected to the electrical source.
It alternates directions of mask motion by means of a hot lead, using the 3-position switches.
120V Wiring Diagram
Red
Rocker
Switch
Up
Off
Down
Side View
Of Switch
And Box
220 / 240V
Wiring Diagram
Up
Off
Down
Rear View Of DPDT,
With Center Off
NOTE: A single switch cannot be used to operate more than
one screen. Contact the factory for further information.
4
To Motor
White
Black
Black With
Yellow
AC Common
AC Hot
120V. 60-HZ 2.5 Max. Amp
This Switch Cannot Be Used With LVC.
NOTE: A single switch cannot be used to operate more than
one screen. Contact the factory for further information.
To Motor
Brown/Yellow
Brown AC Hot
Rocker
Switch
Blue AC Common
220/240V. AC 50HZ
2 Amp. Max
Blue Jumper Wire
Operating Switch,
Switch Box, And
Plate Furnished
With Screen
(SPDT With
Center Off)
In Multiple Control
Installations This Switch Is
Replaced By The Low
Operating Switch,
Voltage Control, Operated
Switch Box, And
From Push Button Stations.
Plate Furnished
With Screen.
NOTE:
Must Be Wired To Conform To
Local Wiring Code. This Switch
Cannot Be Used With L. V .C.
Junction
Box
In Multiple Control
Installations This Switch
Is Replaced By The Low
Voltage Control,
Operated From Push
Button Stations.