Da-Lite Advance 26P Pivoting Da-Lift 26P 매뉴얼

{카테고리_이름} Da-Lite Advance 26P Pivoting Da-Lift 26P에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Da-Lite Advance 26P Pivoting Da-Lift 26P 7 페이지.

페이지 인쇄

Form E-453

Rev. 08 / 10

IMPORTANT INSTALLATION NOTES

If installing this unit in "other space used

for environmental air", it must be installed

with the plenum cover available from

Da-Lite Screen.

This unit must be installed in accordance

with the requirements of the Local Building

Codes, the Canadian Electrical Code

(CEC), CAN/CSA C22.1 and the National

Electrical Code (NEC), NFPA 70.

Suitable for Use in Other Environmental

Air Space in Accordance with Section

300.22(c) of the National Electrical Code,

and Sections 2-128, 12-010(3) and 12-100

of the Canadian Electrical Code, Part 1,

CSA C22.1.

Pivoting Da-Lift

26P and 33P

Caution:

This product is designed for ceiling

installation only. Qualified personnel using the appropriate

fasteners should mount the Pivoting Da-Lift. The surface

to which this unit is mounted must be capable of

supporting a static load of four times the combined weight

of the projector and mount. Do not attach to plaster or

drywall alone.

IMPORTANT SAFETY INSTRUCTIONS

When using your video equipment, basic safety

precautions should always be followed, including the

following:

1. Read and understand all instructions before

using.

2. Position the cord so that it will not be tripped

over, pulled, or contact hot surfaces.

3. If an extension cord is necessary, a cord with a

current rating at least equal to that of the

appliance should be used. Cords rated for less

amperage than the appliance may overheat.

4. To reduce the risk of electric shock, do not

disassemble this appliance. Contact an

authorized service dealer when repair work is

required. Incorrect reassembly can cause

electric shock when the appliance is used

subsequently.

5. The use of an accessory attachment not

recommended by the manufacturer may cause

a risk of fire, electric shock, or injury to

persons.

SAVE THESE INSTRUCTIONS

Required Tools:

7/16" wrench

1/2" wrench

9/16" wrench

Phillips screwdriver