Da-Lite Tensioned Advantage Deluxe Electrol 지침서 - 페이지 3
{카테고리_이름} Da-Lite Tensioned Advantage Deluxe Electrol에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Da-Lite Tensioned Advantage Deluxe Electrol 12 페이지. Automatic electric projection screen
Da-Lite Tensioned Advantage Deluxe Electrol에 대해서도 마찬가지입니다: 사양 (2 페이지), 사양 (2 페이지), 지침서 (12 페이지)
페이지 인쇄
Pre-Installation
1. Carefully unpack screen and remove outer wrapping
from case.
2. Make sure to recheck measurements of screen location
before installation.
Knockouts For
Conduit Installation
Screw For
Securing Roller
Access Door
Fabric Door
Access
Door
Figure 1
Case Installation
1. The case provides multiple attachment points for bolts,
cables, or threaded rod. Page 7 shows threaded rod installed.
The variable position-mounting bracket may be located
anywhere along the length of the case. It is recommended to
keep the brackets spaced evenly enough to distribute the
weight of the screen.
The case has a self-trimming flange around the bottom.
Ceiling tiles or drywall may be placed on top of this flange to
provide a finished appearance.
2. After securing the case in the ceiling check that the case is
level and plumb.
3. Use supplied 1/8" hex key and a 1/4" wrench to remove silver
shipping brackets attached to slat and screen case.
4. Install electrical connections that apply to your unit. Refer to
the following diagrams for proper installation. The diagrams
on page 6 are for standard controls; the diagrams on page 7
are for SCB100 controls and page 8 for SCB200 controls. The
terminal block for the wall switch connections is located
under the metal housing surrounding the junction box.
Remove two screws for access.
NOTE: Use provided knockouts for all electrical connections.
DO NOT drill additional holes into screen case or end cap.
3