Da-Lite TENSIONED CONTOUR ELECTROL 지침서 - 페이지 6
{카테고리_이름} Da-Lite TENSIONED CONTOUR ELECTROL에 대한 지침서을 온라인으로 검색하거나 PDF를 다운로드하세요. Da-Lite TENSIONED CONTOUR ELECTROL 13 페이지. Installer friendly features
Da-Lite TENSIONED CONTOUR ELECTROL에 대해서도 마찬가지입니다: 지침서 (13 페이지), 지침서 (9 페이지), 설치 관리자 매뉴얼 (2 페이지), 사용 설명서 (9 페이지)
페이지 인쇄
Tensioned Contour
220V Wiring Diagram with Operation & Limit Adjustment
Wall Switch
3-conductor 20–24 gauge wire can be used in place of the
supplied RJ-14 cable to connect the wall switch. Connect the BUS
terminals on the wall switch to the corresponding BUS terminals
on the splitter board.
Up Limit
Tactile Button
U P
S T O P
D O W
U P
N
S T O
Down Limit
D O
W N
Tactile Button
Front of
Wall Switch
RJ-22 Jack
(Connection to
Wall Switch)
RJ-14 Pin-Outs
(Tab Is Facing Down)
Bus (RP Data)
White
RQ Data
Green
+5V
Red
Ground
Black
Supplied RJ-14 cable
6
Electrol
Installation for 220V Screens
®
®
U P
S T O
P
D O
W N
LED
P
Bus
Back of
Wall Switch
RJ-22
Jack
RJ-22 Pin-Outs
Bus (RP Data)
RQ Clock
Standard RJ-22 can be used in place of RJ-14 cable
IMPORTANT NOTE: The wall switch is REQUIRED to make any
limit switch adjustments, EVEN if a third party control system is
used. Therefore, it is advised to wire the switch or provide a
3-conductor connection that is accessible.
RJ-22
Output
RJ-22
Inputs
RJ-45 Jack
Power
Wire
Brown
(Common)
Blue
(Hot)
Power Input 220VAC / 50Hz
(Tab Is Facing Down)
+12V
Blue
Yellow
RQ Data
Green
+5V
Red
Ground
Black
White
Up (Dry Contact)
Down (Dry Contact)
Common (Both)
Bus (Bus)
5V (Bus)
RJ-45
Receptacle
Data
Cable
Green / Yellow (Ground)
RJ-45 Pin-Outs
Manual 2
+12V
Bus (RP Data)
RQ Data
+5V
Ground
RQ Clock
Manual 1
(Tab Is Facing Down)
Brown
Blue
Yellow
Green
Red
Black
Orange
Purple