American Standard Glenwall VorMax 2882 Series 설치 지침
{카테고리_이름} American Standard Glenwall VorMax 2882 Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard Glenwall VorMax 2882 Series 4 페이지. Wall-mounted toilet
페이지 인쇄
INSTALLATION INSTRUCTIONS
Glenwall
VorMax
®
Wall-mounted Toilet
2882 SERIES
When installed so top of seat is 17" to 19" (432mm to 483mm) from the nished oor. MEETS THE AMERICANS WITH DISABILITIES ACT
GUIDELINES AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND USEABLE BUILDING FACILITIES - CHECK LOCAL CODES.
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be
sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TWO PEOPLE ARE RECOMMENDED FOR HANDLING TO AVOID
!
BREAKAGE AND POSSIBLE INJURY!
NOTE: For proper operation product requires a minimum of 30 psi working line pressure
RECOMMENDED TOOLS AND MATERIALS
Closet Carrier Support
Putty Knife
Regular Screwdriver
Adjustable Wrench
Recommended fitting type for
back-to-back installations.
1
Pictures may not exactly define contour of china
FINISHED WALL
29-1/2"
(750mm)
9-5/8"
(245mm)
5-1/8"
(130mm)
C/L OF SEAT POST
HOLES 5-1/2"
(140mm CENTERS)
3-1/4"
(83mm)
5-1/4"
(133mm)
3-7/8"
(98mm)
1-3/4"
(45mm)
C/L OF WASTE OUTLET
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2020
®
Sealant
Tape Measure
Carpenters Level
Water Supply Line - Verify length required
BACK-TO-BACK INSTALLATION
18-7/16"
(469mm)
SUPPLY AS
REQUIRED
17"
(432mm)
*7-1/2"
(191mm)
4-1/8" (105mm)
EZ-INSTALL KIT INCLUDED WITH TANK
Depending upon your plumbing and venting conditions, the
flow from the toilet in a back-to-back installation may create
a vacuum on the system and draw water from the opposing
bowl. The National Standards Plumbing Code prohibits the
use of a cross fitting for drainage as throw over is possible.
The code does approve a directional "Y" style fitting with
proper venting to direct the water downward and away from
the other toilet.
17-13/16"
(453mm)
14-5/8"
32-13/16"
(372mm)
(833mm)
9"
(229mm)
*8-1/2"
(216mm)
7-1/2"
(191mm)
4"
(102mm)
Attachment Handle
NOTE: If carrier bolt does not extend
or is flush with china, use
retrofit caps 7381285-200.0070A
(sold separately).
STANDARD BOLT CAP
WALL
CHINA / TOILET
RETROFIT BOLT CAP
WALL
CHINA / TOILET
7302395-100 Rev. 1 11/20
Nuts (3)
STANDARD
BOLT CAP
RETROFIT
BOLT CAP