American Standard LOFT 2535 설치 지침 매뉴얼 - 페이지 2

{카테고리_이름} American Standard LOFT 2535에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard LOFT 2535 13 페이지. 1.28 gpf one-piece toilet compact elongated right height with seat

페이지 인쇄

INSTALL TOILET

a. Position toilet squarely to wall and, with a rocking

motion, press bowl down fully on wax ring and flange.

Alternately tighten nuts until toilet is firmly seated on floor.

CAUTION: DO NOT OVERTIGHTEN NUTS

OR BASE MAY BE DAMAGED!

b. Install caps on washers. (If necessary, cut bolt height

to size before installing caps.)

c. Smooth off the bead of sealant around base. Remove

excess sealant.

INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.

Before continuing, determine the type of water supply connecation you have from

the chart below and use the appropriate assembly parts required to properly

reconnect the water supply. DO NOT use plumber's putty to seal these fittings.

METAL/COPPER

METAL FLANGED

FLARED TUBING

TUBING

LOCK NUT

CONE

WASHER

COUPLING

NUT

WATER

SHUT-OFF

These parts must be used as

illustrated to insure water-tight

connection. Use of existing

coupling nut may result in

water leakage. Water supply

tube or pipe must extend at

least 1/2" inside threaded

shank of valve (does not apply

to flanged tubing).

CAUTION: DO NOT USE

CONE WASHER WITH

PLASTIC SUPPLY LINE.

WARNING: Do not use plumber's putty, pipe dope, or any other sealant on the water supply connection

to this tank. If the connection leaks after hand tightening, replace the supply line. If the connection

continues to leak with the new supply line, replace the fill valve.

Warranty is void if any type of sealant is used on the water supply connection.

METAL SPIRAL

TUBING

LOCK NUT

EXISTING

WASHER

CONE

WASHER

EXISTING

COUPLING

NUT

WATER

SHUT-OFF

Use existing

Use existing spiral

coupling nut

cone washer.

and washer.

Fluidmaster cone

washer may not

seal completely on

spiral type supply

line.

CAUTION: Overtightening of

LOCK NUT or COUPLING NUT

could result in breakage and

potential flooding.

BOLT CAP

BOLTS

VINYL/BRAIDED

CONNECTOR

LOCK NUT

COUPLING

NUT

WATER

SHUT-OFF

Captive cone

washers already

included. No

additional washers

needed.

- 2 -

CLOSET FLANGE

With correct washers in place

(see Step 8a), tighten COUPLING

NUT 1/4 turn beyond hand tight.

DO NOT OVERTIGHTEN.

7 302 010 - 10 0 Rev. A