American Standard Milano CCAS1830 설치 매뉴얼 - 페이지 4
{카테고리_이름} American Standard Milano CCAS1830에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard Milano CCAS1830 4 페이지.
페이지 인쇄
TROUBLE SHOOTING GUIDE
Problem
1. Poor flushing action
2. Water won't stop
running
3. Water supply hose
leaks
CARE AND MAINTENANCE
Do not use harsh abrasives or caustic cleansers to clean fixture surface. A mild detergent, warm water, and a
softcloth will remove normal dirt and soap accumulations from fittings and surfaces. Rinse thoroughly after
cleaning and polish with a soft dry cloth to restore original luster of material.
NOTICE
DO NOT USE CLEANERS IN TANK.PRODUCTS CONRAINING CHLORINE (CALCIUM HYPOCHLORITE CAN SERIOUSLY
DAMAGE FITTINGS INTHE TANK.THIS DAMAGE CAN CAUSE LEAKAGE AND PROPERTY DAMAGE.AMERICAN STANDARD
SHALL NOT BE RESPONSIBLE OR LIABLE FOR ANY TANK FITTING DAMAGE CAUSED BY THE USE OF CLEANERS
CONTAINING CHLORINE (CALCIUM HYPOCHLORITE).
AMERICAN STANDARD ONE-YEAR LIMITED WARRANTY
If inspection of this product, within one year warranty after purchasing, confirms that its defective under normal
use in material or workmanship. We will repair or, at its option exchange the product of a similar model.
THE WARRANY DOES NOT COVER THE FOLLOWING:
1.NONE ANY DOCUMENTARY EVIDENCES TO SHOW THE PERIOD OF WARRANTLY SUCH AS RECEIPT,WARRANTY
CARD, ETC.
2.CONSEQUENTIAL OR INCIDENTAL DAMAGES.
3.DEFECTS OR DAMAGES ARISING FROM SHIPPING,INSTALLATION,ALTEMATION,ACCIDENTS,MISUSE OR LACK
OF PROPER MAINTENANCE.
4.POSTAGE OR SHIPPING COSTS INCURRED IN RETURNING PRODUCTS FOR REPAIR OR REPLACEMENT UNDER
THIS WARRANTY AND ANY LABOR OR OTHER COSTS OR REMOVAL OR INSTALLATION OF PRODUCTS UNDER
THIS WARRANTY.
5.A PRODUCT DISCONTINUOUS.
Using this guide and referring to the accompanying instructions should help you solve most
common problems encountered.
Possible Cause
a. Water level in tank is below prescribelevel.
b. Flush valve mechanism in tank closes too quickly
or does not open.
c. Flush handle or button needs replacing.
d. Water pressure is too low.
e. Partially clogged trapway and / or drainpipe.
f. Cleanser used in tank deposits residue.
g. No air vent.
a. Water level in tank is higher than overflow pipe.
. b
T
u
n r
o
f f
h t
e
w
t a
r e
s
u
p
p
. y l
f I
flow into the bowl the flush valve seat and / or
rubber seal disk are worn or deforme d.
c. Turn off the water supply valve. If water continues
to flow into the bowl until the water level falls to
h t
e
e l
v
l e
f o
h t
e
o
v
e
f r
o l
w
p
p i
be lodgeg in the water control mecha nism.
d. Flush valve string is too tight, holding the flush
valve open.
e. Button needs replacing.
a. Improper installation
b. Water pressure is too high.
No.24 Building, Gems Park, No.487 Tianlin Road,
Shanghai, P.R.China, Post code: 200233
Tel:(86-21) 33952888 Fax:(86-21) 33674255
Http://www.americanstandard.com.cn
w
t a
r e
c
o
t n
n i
u
e
s
o t
, e
s
a
n
d
r o
d
e
r b
s i
m
a
y
Hotline: 800-820-3191
- 4 -
To Correct
a. Set to prescribed level.
b. Make sure there are no any material stuck
to outlet components.
c. Replace.
d. Normal water supply pressure must be at least
20 psi.
e. Use a plunger or toilet augur to unclog.
f. Clean out tank and cease using the cleanser.
g. Install air vent per instructions.
a. Adjust the cylinder to maintain the water at the
prescribed level.
b. Replace seat, rubber seal disk, or complete
assembly, as needed.
c. Shut off water supply valve. Remove top cap
of water control. Clean and reassemble, or
replace plunger.
d. Replace fulsh valve unit.
e. Replace button.
a. Reinstall, according to instructions.
b. Water pressure must not exceed 80 psi.
Dec.14
Rev.01