DAAB DB409 사용 설명서 - 페이지 6

{카테고리_이름} DAAB DB409에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAAB DB409 12 페이지. Interface card for frequency converter vfd-el

페이지 인쇄

Installing the Delta VFD-EL frequency converter

• Modification of the motor winder

The following criteria must be met in order to use the DAAB motor winder with the frequency converter:

• If mechanical limit switches are used, the limit switch cams must be wider than normal.

• FAAC Nordic AB recommends using encoder-type limit switches, DB405, together with the frequency converter.

• FAAC Nordic AB recommends using a motor with a speed of 2,800 rpm.

• Programming the frequency converter

To program the frequency converter, press ENTER once to select programming mode. Select program group 00.xx to 11.xx

using the arrow keys. Press ENTER to select program group. The program arrows now switch between the different program

channels in the selected program group. Press ENTER once more at the selected program channel and select value using the

arrow keys. When you have set the desired value, press ENTER again to save the new value. When all the programming has

been done, you return to normal operation by pressing MODE until the display shows H for the output frequency concerned.

Tip: By pressing MODE once more when stepping between the program channels, you change to stepping between the

program groups instead.

• Channel settings in the frequency converter

Channel

no.

00.03

used to display the output frequency during operation after power is

switched on

01.00

used to set the maximum output frequency

01.03

used to set the low frequency

01.04

used to set the low frequency voltage

01.05

used to set the start frequency

01.06

used to set the start frequency voltage

02.00

used to set where the setpoint value for speed is to be taken from

02.01

used to set the start method

02.02

used to set the type of stop

02.04

used to block reversing

03.00

used to set the multifunction output

03.08

used to set the internal cooling fan

04.04

used to set the function of input MI1

06.01

used to set the current limit for a speed increase

06.02

used to set the current limit at constant speed

06.06

used to set the electronic overload relay

09.00

selects communication address: 1 for motor 1, 2 for motor 2

09.01

used to set transfer speed

09.02

used to set error handling

09.07

used to set time delay between messages

Description

DAAB INTERFACE CARD DB409 INSTRUCTION MANUAL

Factory

Modified

setting

value

100.0

5.00

40.0

1.50

30.0

200

Revision 7