DAAB DB406 사용 설명서 - 페이지 2

{카테고리_이름} DAAB DB406에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DAAB DB406 8 페이지.

Installation

1. Disconnect the power to the EP104

2. Screw the DB406 board into place on the spacers on the EP104 using two M3x5 screws.

Connection

The frequency converter being connected to the DB406 must be a DELTA VFD-EL or equivalent. This frequency converter

is based on negative logic. Connect the frequency converter according to the example below which shows a DELTA VFD-EL.

Refer to the diagram on the next page for full details regarding signals and connecting electric motors. The information below

relates to the connections illustrated on the following page.

Ensure that all cables are disconnected from the terminals indicated in the diagram below. Also note the direction in which

the cable is routed through the coil. If this is not correct, the frequency converter and the automatic control unit may be

permanently damaged. After the modification described below, N and T1 will be an input and not an output.

Pass the cable

from T1 through

this hole

Pass the cable

from T1 through

this hole

Remove

DAAB OUTPUT CARD DB406 INSTRUCTION MANUAL

Remove