American Standard 2732 설치 지침 - 페이지 2
{카테고리_이름} American Standard 2732에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard 2732 3 페이지. Bathing pool
American Standard 2732에 대해서도 마찬가지입니다: 설치 매뉴얼 (15 페이지)
페이지 인쇄INSTALLATION AND FRAMING INSTRUCTIONS
The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs as
required. Ensure roughing-in dimensions are proper, plumb and square. It is strongly recommended that an additional opening be
provided for access to the drain components.
1.
As shown in Fig. 1, mark the position of the underside of the deck by tracing a line onto the studs at the height
indicated, using a level or other suitable straight edge.
2.
With the top of the 2 x 4 stringer touching the traced line, attach the stringer to the studs.
3.
Install drain components to the tub following the manufacturers instructions. Before replacing your tub for final installation,
be certain that an opening has been provided in the sub-floor for the drain. See the roughing-in drawing for suggested
opening size and location dimensions.
4.
This bath must be supported along its entire bottom in all types of installations. Use mortar or plaster as bedding material
(sand is not recommended). Apply enough bedding to support the complete bottom of the bath. After the bedding has been
poured, and before it sets, lower the bath into place until the rim is leveled against the leveling stringers (see "Typical
Installation Methods"). The rim of the bath MUST NOT support weight. Allow the bedding material to completely harden
before applying weight to the rim or bottom of the bath. Any finish material such as tile or wall board must be self-supporting
if it contacts the deck of the bath.
FIG. 1
464mm
(18-1/4")
TYPICAL RECESS INSTALLATION
464mm
(18-1/4")
1529mm
(60-3/16")
LEVELING
STRINGERS
610mm
(24")
TILE
BEAD
STRIP
NOTE: Tile bead kit not included and must be
purchased separately.
TYPICAL PIER TYPE INSTALLATION
AS DESIRED
794mm
(31-1/4")
CUTOUT
464mm
(18-1/4")
AS DESIRED
LEVELING
SURFACE
WATERPROOF
SEALANT
BATH
(2)
TILE
WALLBOARD
SEALANT
BATH
ADHESIVE
LEVELING
STRINGER
1486mm
(58-1/2")
CUTOUT
610mm
(24")
752480-100 Rev. H 8/16