Canon Color imageCLASS MF8350Cdn 시작 설명서 - 페이지 17
{카테고리_이름} Canon Color imageCLASS MF8350Cdn에 대한 시작 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon Color imageCLASS MF8350Cdn 33 페이지. Canon imageclass mf8350cdn: quick start
Canon Color imageCLASS MF8350Cdn에 대해서도 마찬가지입니다: 시작 설명서 (29 페이지), 시작 설명서 (28 페이지)
![Canon Color imageCLASS MF8350Cdn 시작 설명서](/uploads/products/server2/1123872/1123872.png)
1
2
Preface
Installing the Machine
Selecting a Method for Connecting the
Machine to a Computer
There are two ways to connect the machine to a computer: Network connection and USB connection. Select the
connection type according to your environment or functions to be used.
*
Functions with USB connection and network connection can be used simultaneously.
*
To use the scanning function with Macintosh, you need to connect with a USB cable.
•
For Network Connection
Network Connection and Configuration
The procedures for connecting to and configuring a network are the same
for Windows and Macintosh.
Connect to and configure a network using the following procedure.
*
Installation methods for the software are different. After connection and
configuration, see the relevant pages for the respective procedures for installation.
Network Connection and Configuration
( Windows/Macintosh)
1.
Connect the LAN cable.
2.
The machine sets the IP address
automatically.
Wait approximately 2 minutes.
If you want to set the IP address manually, see the following.
e-Manual "Setting IPv4 Address"
e-Manual "Setting IPv6 Address"
•
For Windows
Installing via Network Connection P. 16
3
Configuring and Connecting the Fax
Connect the cable.
Make sure that the
green indicator of
the LAN port is on.
Installing via Network Connection
4
Connecting to a Computer and
Installing the Drivers
•
For USB Connection
•
For Windows
Installing with USB Connection P. 18
•
For Macintosh
Installing the Software P. 21
About the LAN cable
•
The machine does not come with a LAN cable or a hub.
Have cables or a hub ready as needed.
•
Use a Category 5 or higher twisted pair cable for the
LAN.
About obtaining the IP address automatically (AutoIP)
<DHCP> or <Auto IP> is enabled in the default setting.
Even if you do not set the IP address manually, this machine can
obtain it automatically.
•
Even if you do not have a dedicated device such as a DHCP server,
the IP address is obtained automatically.
•
The <DHCP> setting is prioritized over <Auto IP>.
If a fixed IP address is set as the IP address of the computer, set the
fixed IP address also for this machine manually.
If the IP address of the machine is changed
When the machine and computer are on the same subnet, the
connection is maintained.
•
For Macintosh
Installing the Software P. 21
Appendix
If the indicator is not on
Check the following.
•
Whether the machine and hub are
connected using a LAN cable
•
Whether the power of the machine is
turned ON
15