American Standard EVERCLEAN 2422L.068C 설치 및 운영 매뉴얼 - 페이지 12

{카테고리_이름} American Standard EVERCLEAN 2422L.068C에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard EVERCLEAN 2422L.068C 14 페이지. Air baths

BATHING:

• Close drain by rotating Drain Overflow Knob COUNTER-CLOCKWISE

• Fill bath with water at a comfortable bathing temperature, adding bath oils or salts as desired.

OPERATING AIR MASSAGE SYSTEM:

EXITING THE BATH

• Be sure to turn off the air blower before draining bath.

• Open drain by rotating drain knob clockwise.

STANDARD DRYING CYCLE

An automatic drying cycle will start 20 minutes after the blower is turned off. The blower LED blinks while waiting

for the purge cycle.

24H PROGRAMMABLE DRYING CYCLE

The system must be stopped prior to activation or deactivation.

Activation: Determine at which time you wish to purge to activate. At that precise time, press and hold the second button

on the keypad for 5 seconds, all LEDs will flash twice. The purge cycle will now start at the programmed time every

24 hrs. In the event of a power failure, the program will be automatically deactivated.

Deactivation: Press and hold the second button on the keypad for 5 seconds, all LEDs will flash once to confirm deactivation.

754072-100 Rev. A

Operation: Air Bath

ON/OFF:

Press this button once to turn air-blower on.

Press again to turn air-blower off.

AIR SPEED INCREASE:

Pressing this button will increase to the next higher speed.

AIR SPEED DECREASE:

Pressing this button will decrease to the next lower speed.

WAVE FUNCTION:

Press this button to start the wave function (button will light).

Blower speed will continuously vary between high and low.

Press again to exit wave function (button light will go out).

DRYING CYCLE OPTIONS