Donaldson Torit TBI 20 설치 및 운영 매뉴얼 - 페이지 11

{카테고리_이름} Donaldson Torit TBI 20에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Donaldson Torit TBI 20 20 페이지. Backward inclined fan

페이지 인쇄

1. Table of Contents

5. Apply sealer on the inlet spool piece and re-attach

the TBI fan to the inlet spool piece. Be sure to

position the discharge to be free of obstructions

and locate so that the motor's electrical box will be

positioned for wiring convenience.

6. Inspect the installation prior to starting the fan.

Check for any loose items or debris that could be

drawn into the fan or dislodged by the air discharged

from the fan outlet. Check the interior of the fan as

well. Turn the wheel by hand to check for binding.

7. Complete the electrical connections in accordance

with NEC code and state and local codes. "Bump"

the starter to make sure the motor is rotating in

the proper direction. (Standard TBIs are clockwise

rotation as viewed from the motor endbell.)

Motor Drain Hole Orientation

(Side Mount Fans)

Motor drain holes must be oriented downward to prevent

water accumulation in the motor and extend motor life.

Torit Backward Inclined Fan, TBI-3 through 30

Fan with Inlet Spool Piece Mounted to

Clean Air Outlet with Adapter

The following instructions are for a TBI fan being

mounted to a Donaldson Torit dust collector that has a

side mount adapter.

1. Apply sealer, furnished in the installation hardware

kit, around the clean air outlet opening of the

collector. Sealer should be applied in a Figure 8 type

pattern around each bolt hole so that inlet is sealed

from both the outside and the inside of the bolt hole.

2. Bolt the TBI fan to the adapter by inserting the

bolts on the TBI inlet into the appropriate holes

of the adapter. Install the nuts that came with the

fan. Be sure to position the discharge to be free of

obstructions and locate so that the motor's electrical

box will be positioned for wiring convenience.

3. Inspect the installation prior to starting the fan.